Determine the resistance and power of the bulb

Assignment Help Physics
Reference no: EM13251578

A simple circuit consists of a light bulb connected to the terminals of a battery. A voltmeter shows a potential difference of 12.0 V across the light bulb, whereas an ammeter registers a current of 0.500 A in the circuit. Determine the resistance and power of the bulb.

Reference no: EM13251578

Questions Cloud

What is the natural frequency of oscillation : A 0.5 kg mass attached to a linear spring, with spring constant 5 N/m and damping constant 0.2 kg/s, What is the natural frequency of oscillation
Find the width of the slit : A laser beam passes through a single slit. We observe an interference pattern on a screen 9.03 m away. Find the width of the slit
Find the angular momentum of the mass : the motion of a 25.0kg mass on the end of a string is uniform motion. the magnitude of the tangential velocity of the mass is 5.0m/s. calculate the angular momentum of the mass
Proportional representation electoral systems : Research hypothesis: Turnout tends to be higher in proportional representation electoral systems and research hypothesis: A country's predominant religion influences its democratic status today
Determine the resistance and power of the bulb : A simple circuit consists of a light bulb connected to the terminals of a battery. Determine the resistance and power of the bulb
Calculate the energy stored in the capacitor : The plates of a parallel-plate capacitor are charged to a potential difference of 12.0 V. If the capacitance is 15.0 µF, calculate the energy stored in the capacitor
Determine the potential and the electric field : A +2.7 µC charge is 32 cm to the right of a -5.3 µC charge. At the midpoint between the two charges, determine the potential and the electric field
Determine the electric potential energy of a third proton : Two protons are located on the x-axis at 1.0m and on the y-axis at 1.5m. Determine the electric potential energy of a third proton located at the origin
Determine the temperature of the gas : An ideal gas is brought throught an isothermal compression process. what are the temperature T of the the gas and the final pressure Pt

Reviews

Write a Review

 

Physics Questions & Answers

  Find out the gravitational force of attraction

A 2200 kg sport utility vehicle travelling at 86 km/h can be stopped in 0.15 s if it hits a concrete wall. Presume a 60 kg person was in the car that hit this wall. The velocity of the person equals that of car both before and after the crash, and..

  How many revolutions will the car

An airplane must reach a speed of 189mi/h to take off. If the runway is 472m long, what is the minimum value of acceleration that will allow the airplane to take off successfully.

  Find the index of refraction for violet light in plastic

The index of refraction for violet light in plastic is greater than that for red light by 0.0410. Delaying any rounding off of calculations until the very end, find the index of refraction for violet light in plastic.

  Find out kinetic energy of the merry-go-round

Find out kinetic energy of the merry-go-round

  Find the efficiency of this cycle

The working substance of an engine is 1.00 mol of diatomic gas. The engine operates in a cycle consisting of three steps, Find the efficiency of this cycle

  What size resistor should be placed in series

A galvanometer has a coil resistance of 29.0 ?. It is to be made into a voltmeter with a full-scale deflection equal to 100.0 V, what size resistor should be placed in series with the galvanometer

  How much work is prepared on the gas

An ideal gas is enclosed in a cylinder that has a moveable piston on top. The piston has a mass of 6200 g and an area of 5 cm2 and is free to slide up and down.

  Draw a spacetime diagram of the situation

A rock is lauched from the moon and travels away from it at a speed of 2/5, Call the event of the rocket's lauching event A, Draw a spacetime diagram of the situation, drawing and labeling the worldlines of the moon

  Find out the coefficient of sliding friction

Find out the coefficient of sliding friction

  What is the intensity of light emerging from p1

A beam of unpolarized light of intensity 12.o w/m^2 is incident on an ideal linear polarizer, P1, whose transmission axis is in the vertical (y) direction, What is the intensity of light emerging from P1

  Explain how much longer would the jump be

What was the take-off speed? If this speed were increased by just 5.0%, explain how much longer would the jump be?

  Calculate the mass of the sand

A 28.0 kg block is connected to an empty 2.00 kg bucket by a cord over a frictionless pulley, Calculate the mass of the sand added to the bucket.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd