Determine the rate of heat transfer from the air

Assignment Help Mechanical Engineering

Reference no: EM13709967

Air enters the evaporator at 14.7 psia and 90 F with a volumetric flow rate of 200 ft3/min. Refrigerant 134a at 20 psia with a quality of 30 % enters the evaporator at a rate of 4 lbm/min and leaves as saturated vapor at the same pressure. Assume steady state operation and negligible pressure changes through the evaporator. Also, assume the air behaves as an ideal gas with constant speci¯c heats. Determine:

a. the rate of heat transfer from the air [Btu/min]

b. the exit temperature of the air [F]

Reference no: EM13709967

Questions Cloud

Piston-cylinder assembly with an initial volume : A piston-cylinder assembly with an initial volume of 0.01m^3 is filled with saturated refrigerant 134a vapor at 16 degrees Celsius. The substance is compressed until a state of 9 bars and 60 degrees Celsius is reached. During the compression process,..

Pressurisation process the system is being colled or heated : A batch of a certain substance (a simple system) is held in a constant volume, rigid container. The system experiences an infinitesimal change of state during which the pressure rises. The question is whether during this constant volume pressurisatio..

Expressions for helmoltz free energy fundamental relation : Derive analytical expressions for the helmoltz free energy fundamental relation of a single component ideal gas F(t, v, n) and for the Gibbs free energy fundamental relation of the same substance G(t,p,n)

Find the speed of the water leaving the nozzle : A fire truck draws water from an open constant-level reservoir through a hose of 0.2 ft2 cross section. The water is discharged from the pump through another 0.2 ft2 hose to a surge tank pressurized to 120 psig with air at the top. The pump adds 970 ..

Determine the rate of heat transfer from the air : Air enters the evaporator at 14.7 psia and 90 F with a volumetric flow rate of 200 ft3/min. Refrigerant 134a at 20 psia with a quality of 30 % enters the evaporator at a rate of 4 lbm/min and leaves as saturated vapor at the same pressure. Assume ste..

Consider a cylindrical specimen of a steel alloy : Consider a cylindrical specimen of a steel alloy 8.0 mm (0.3150 in.) in diameter and 89 mm (3.504 in.) long that is pulled in tension. Determine its elongation when a load of 57810 n (13000 lbf) is applied. The tensile stress-strain behavior for this..

Determine the power rating of the electric heater immersed : You are assigned to design a heating system for a swimming pool that is 2 m deep, 20 m long and 20 m wide. The client desires that the heating system be large enough to raise the water temperature from 2 C to 3C in 2 hours. The rate of heat loss from..

Determine the distance from the leading edge of the plate : Air at 25°C and 1 atm is flowing over a long flat plate with a velocity of 8 m/s. Determine the distance from the leading edge of the plate where the flow becomes turbulent, and the thickness of the boundary layer at that location.

Find the thrust force of the engine : A high-speed boat is powered by a water jet pump engine, similar to a jet engine on airplanes. The engine takes in water at the bow through a tube with diameter 1 ft, and the water is pumped out the stern of the boat through a 3-in diameter tube.

User Account

All Pages