Determine the power generated by turbine in steady state

Assignment Help Civil Engineering
Reference no: EM13306403

Determine the power generated by the turbine (in KW) operating in steady state at 5MPa, with specific enthalpy 3000kj/kg and velocity of 10m/s at the entrance and steam escaping at 0.07MPa, specific enthalpy 2000kj/kg at velocity of 90m/s p. The inlet is located 1m above the outlet and mass flow rate is 11kg/s.

Reference no: EM13306403

Questions Cloud

Erection of additional transmission lines : NATIONAL NZ ELECTRICITY TRANSMISSION GRID - Erection of additional Transmission Lines
Derive the pro frontier and explain why total pro : Derive the pro?t frontier, and explain why total pro?ts fall as the ?rms redistribute pro?t between themselves by redistributing output.
What is the temperature of the sun : The solar energy coming to the earth by radiation is 1,340 W/m If the sun has a radius of 7.000*10^8m, what is the temperature of the sun
What protocol unit is being used in layer 2 : Network switches provide essential connectivity in local and wide area networks. Some of them run in multilayer between layers 2 and 3. What protocol unit is being used in layer 2?
Determine the power generated by turbine in steady state : Determine the power generated by the turbine (in KW) operating in steady state at 5MPa, with specific enthalpy 3000kj/kg and velocity of 10m/s at the entrance and steam escaping at 0.07MPa, specific enthalpy 2000kj/kg at velocity of 90m/s p.
Find specific weight and total moisture content of sample : A sample of dry sand with a specific gravity total of 16.49 kN/m3 and a relative density of 2.67 grains, is placed outdoors. During a rainy period, the sample volume remains constant but the degree of saturation increases to 40%.
Focus on the fundamental aspects of operations : OBJECTIVES:The purpose of this assessment is to focus on the fundamental aspects of Operations & Quality Management as it applies to an organizational structure adopted by the organization.
Create any required pointers needed to complete insertion : Assume that the list pointed to by startPtr is maintained in alphabetical order. (Note: you do not know what is in the list, only that it is maintained in alphabetical order.)
Would a sort routine more likely be used with an array : Would a sort routine more likely be used with an array or a linked list? Explain your answer.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Explain which is 625 feet long connects two bodies of water

A pump is to be used to draw seawater from the bay at an elevation of 0 to a reservoir at a desalination plant that has a water surface elevation of 255 feet. A 12-inch diameter DIP pipe (CHW = 120) which is 625 feet long connects the two bodies ..

  Calculate the total friction force exerted by the road

A 3220-lb car enters an S-curve at A with a speed of 60 mi/hr with brakes applied to reduce the speed to 45 mi/hr at a uniform rate in a distance of 300 ft measured along the curve from A to B.

  Integrate the rate equation and solve for the concentration

Investigators have determined that the rate equation for bacterial kill in batch chlorine contact chambers is: rxn rate = dC/dt=-kCt where C is the concentration of bacteria, k is the rate constant, and t is time.

  Estimate the change in pressure over 100 m of pipeline

Water at 20 degrees flows at a velocity of (V =) 2 m/s in a (D =) 250-mm diameter horizontal ductile iron pipe. Estimate the friction factor f in the pipe, and state whether the pipe is hydraulically smooth or rough.

  Determine the level of service for the segment

Determine: a. the Level of Service for this segment; b. the loss in Level of Service, if due to construction the lane width is reduced to 10 feet and there are concrete barriers one foot away from either end of the pavement.

  How many cubic meters of water are needed

Establish a grass cover over a 10ha landfill. The root zone of the grass is 40cm deep. Increase the volumetric water content of root zone from 12% to 24%. How many cubic meters of water are needed?

  Solve given differential equation by separation of variables

Given computer-generated direction field. Then sketch, by hand, an approximate solution curve that passes through each of the indicated points. Use different colored pencils for each solution curve.

  How would the economies of construction be obtained

For a metal and wood structure, how would the economies of construction be obtained (pertaining to the mean and standard deviation of a probability of failure graph)?

  Determine the landing speed of the airplane if it travels

A 32000 lb airplane lands on an aircraft carrier and is caught by an arresting cable. The cable is inextensible and is paid out at A and B from mechanisms located below deck and consisting of pistons moving in long oil-filled cylinders.

  Determine the pressure difference between a and b

Fluids A and B ave specific gravities .75 and 1.00 respectively. If the mercury is used as manometer liquid determine the pressure difference between A and B

  Calculate the elastic recovery

A 10-mm diameter bar of 1040 carbon steel is subjected to a tensile load of 50,000 N, taking it beyond its yield point. Calculate the elastic recovery (or strain) that would occur upon removal of the tensile load.

  Determine the power output of the engine in each cycle

If it absorbs 100 Joules each cycle from the hot reservoir, how much work does it do. How much heat is given off in each cycle If each cycle takes 0.5 seconds, find the power output of the engine.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd