Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The depth of flow in a long canal with a trapezoidal across section is 2 meters. The discharge is 15 cubic meters per second with a bottom width=10m and side slopes of 1V:2H. If the discharge is increased to 20 cubic meters per second determine the new depth of flow?
A 48-in water main carries 79 cfs and branches into two pipes at point A. The branching pipes are 36 and 20 in. in diameter and 2800 and 5000 ft long, respectively. These pipes rejoin at point B and again form a single 48-in.
A tank operated as a CFSTR used to remove benzene from a flow stream is 1500 m3 in size. The flow rate in and out of the tank is 8 m3/day. If the influent benzene concentration of 265 ug/L and the effluent concentration is 12 ug/L
a tape is calibrated and found to measure 100.04ft between the 0- and 100-ft marks. what measurements should be laid out to establish a horizontal distance of 682.25ft?
A 3m deep layer of clay is underlain by impervious rock. An extensive area of fill is to be placed over the site. How long would it take for the clay layer to achieve 90% of its total final settlement.
determine the elastic elongation that would be expected for a 16-mm-diameter rod of the same material if the rod were 1.6 m long and subjected to a tension force of 3.3 kN.
An activated sludge aeration tank has a width of 14m, a length of 15m and an effective liquid depth of 4.5m. The secondary clarifier has a diameter of 25m. The plant operating parameters are as follows
Determine the coefficient of thermal expansion (in m/m.K) for the material over the temperature ranges - Determine i. the phases present
A ball is thrown vertically upward with a speed of 15m/s. Determine the time of flight when it returns to its original position.
The reaction between 2-methyl-2-pentanol and HBr to yield 2-methyl-2-pentene is probably: A) an E1-type reaction involving the protonated alcohol as the substrate. B) an SN2-type reaction involving the protonated alcohol as the substrate.
water flows from a lake as is shown in fig. p8.40 at a rate of 4.0 cfs. is the device inside the building a pump or a turbine? Explain and determine the horsepower of the device. neglect all minor losses and assume the friction factor is .025
The routes are currently in user equilibrium. A reconstruction project on route 1 reduces capacity to 3.0 kvph, but total travel demand is unaffected. Field studies note a 35.28 sec increase in average travel time
A cylindrical rod with a length of 380 mm and a diameter of 10 mm is to be subjected to a tensile load. The rod must not experience plastic deformation or an increase in length of more than 0.9 mm when a load of 24.5 kN is applied.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd