Determine the minor loss coefficient k for a valve

Assignment Help Civil Engineering
Reference no: EM13319947

A town is installing a new 10" main to carry drinking water. The only section remaining to be installed is a segment through the middle of town. However, the excavators discover an archaeological site. The town decides to split the main into two sections, each looping around the site and reconnecting at the other end. The mayor decrees that "the velocity in each branch around the site shall be equal". The town lays 800 feet of 6" pipe to the north of the site and connects to the 10" main leading away from town. However, the town then finds out there is no more 6" pipe. Anywhere. The only pipe available is 8" pipe. The contractor, noting that "shall" is a legally binding term when a contract is signed, must lay the proper amount of 8" pipe such that the velocity in the two branches is the same. Determine: a) the length of 8" pipe required, b) if instead, 800 feet of 8" pipe is laid parallel to the 6" pipe, the minor loss coefficient, K, for a valve that must be placed in the 8" line to exactly cause the velocities in the two pipes to balance. Assume for purposes of solving this problem that turbulent flow exists and the resistance coefficients, f, for the 6" pipe and 8' pipe are 0.023 and 0.019, respectively.

Reference no: EM13319947

Questions Cloud

How the fed targets the fed funds rate : Why the Fed targets but does not set the Fed Funds Rate? How the Fed targets the Fed Funds Rate? How the tools for targeting the Fed Funds Rate and the economy are linked?
How much radiant energy per second comes from the nickel : the U.S. five-cent coin, the nickel, has a mass of 5.1 grams, a volume of 0.719 cm^3, and a total surface area of 8.54 cm^2. how much radiant energy per second comes from the nickel
What will be the discharge through the pipe : A pump having the characteristics given ( N=2133.5 rpm, n=35.6 rps, D=37.1 cm) pumps water at 25 degree C from a reservoir at an elevation of 366 m to a reservoir at an elevation of 450 m through a 36 cm steel pipe
Difference between calculus and business calculus : What is the difference between calculus and business calculus?
Determine the minor loss coefficient k for a valve : A town is installing a new 10" main to carry drinking water. The only section remaining to be installed is a segment through the middle of town. However, the excavators discover an archaeological site.
Find the power consumption of the accelerator : In a certain particle accelerator, a current of .5mA is caried by a 5-MeV proton beam that has a radius of 1.5 mm. Find the power consumption of the accelerator
What contour interval will be drawn if 50ft interval is used : An area that varies in elevation from 463ft - 634ft is being mapped. What contour intervals will be drawn if a 50ft interval is used. Which lines are emphasized.
Interior decorating firm-costing system and applies overhead : Insides, an interior decorating firm, uses a job order costing system and applies overhead to jobs using a predetermined rate of $17 per direct labor hour. On June 1, 2010, Job #918 was the only job in process. Its costs included direct material of $..
Calculate speed of light in glass : A light ray incident on equilateral glass prism, shows minimum deviation of 30degree. Calculate speed of light in glass

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the tension in each of the cables at a time

A long trough is supported by a hinge along its lower edge and a series of horizontal cables attached to its upper edge. Determine the tension in each of the cables, at a time when the trough is full of water.

  How much power is required to overcome aerodynamic drag

a new sports car has a drag coefficient of 0.30 and a frontal area of 21 ft^2, and is traveling at 119 mi/h. how much power is required to overcome aerodynamic drag if p = 0.002378 slugs/ft^3

  Find who has positive breathalyzer test is actually driving

a police officer stops a speeding driver on saturday nigt and gives hima breathalzer test. the test shows that his estimated blood alcohol content is above .08 g/dl, and this is considered evidence of driving while intoxicated

  Determine the corresponding constant rate of acceleration at

If the maximum total acceleration of the train must not exceed 1.5 m/s^2, determine the shortest distance in which the train can reach a speed of 72 km/h, and determine the corresponding constant rate of acceleration at.

  Discuss in detail firm should put in place to make sure wish

Each of the three partners realizes that in order for the firm to continue at the present rate of growth a realistic business continuation plan must be in place which would include a viable buy-sell agreement between the shareholders.

  Discuss and explain the apparent contradiction

The actual weight of the Rectangular Aluminum Beam (used in Task 3) is 25 grams, while the actual weight of the Square Aluminum Box Beam is only 5 grams. But under the maximum applied force (500 grams),

  Determine unstretched length of each rod neglect the weight

The spring loaded supporting rods AB and AC in the figure below aer used as shock absorbers for transporting fragile loads. Knowing that the elastic spring constants for the rods AB and AC are kab = 1.2 kN/m and kac = 1.5 k N/m

  Determine the pressure required to fill the container

If intake1=0m and intake2=0.5m, find the pressure required to fill the container when h=0.75m at both point 1 and 2. Assume the air is at atmospheric pressure until the water level passes intake 2 and the air follows isothermal compression.

  Determine the maximum in-plane shear stress on the wall

a). Determine the state of stresses in the walls and indicate these stresses (including arrows to denote the direction of the stresses) on the element below. b). Then, determine the maximum in-plane shear stress on the wall of the pipe using Mohr's..

  Designing ramp for the highest horizontal curve

the maximum degree of curvature can be at most 6.0 and the superelevation can be at most +6.0%. Design the ramp for the highest horizontal curve design speed given the constraints.

  Calculating coefficient of permeability

The temperature was 200C, and the void ratio (e) of the soil was 0.43. Calculate the "Coefficient of Permeability" in "centimeters per second" (Given, k = (QL)÷(A Δh t)).

  What will be the new level of service

If an additional 11-ft lane is added (each direction) and all other factors stay the same, what will be the new level of service?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd