### Determine the increase in vertical stress at 2m below ground

Assignment Help Civil Engineering
##### Reference no: EM13324081

Three parallel line loads of 500kN/m are applied at ground level in a straight line 4.0m apart. Determine the increase in vertical stress at 2.0m below ground level beneath the middle load. Assume that the soil satisfies Boussinesq's assumptions.

#### Determine speed of the ball when it hits the bottom of lake

A ball is dropped from a boat so that it strikes the surface of a lake with a speed of 19.5ft/s. While in the water the ball experiences an acceleration of a = 10 - 0.8v, wh

#### Calculate the temperature of flat world that has an albedo

Calculate the temperature of "flat world" that has an albedo of 0.31 and a solar flux of 1370 w/m^2. One side of flat world faces the sun. Ignore energy emitted from the edg

#### Determine what is the maximum speed attainable by the car

A driver traveling on a roadway decides to overtake a slow-moving truck traveling at 15 mph. The accelerating characteristic of the car is given by the following: dv/dt= 2.0

#### Determine z components of the electric field in a region

An electron has an initial velocity with an x component of zero, a y component of 9.35 km/s, a z component 16.1 km/s, and a constant acceleration of 1.60 x 1012 m/s2 in the

#### What are the problems associated with bridge widening method

In bridge widening projects, the method of stitching is normally employed for connecting existing deck to the new deck. What are the problems associated with this method in

#### What is the total delay per cycle and delay per vehicle for

A left-turn movement has a maximum arrival rate of 200 veh/h. The saturation flow of this movement is 1400 veh/h. For this approach, the yellow time is 4 seconds, all red time

#### Find where building should be located relative to centreline

A developer has requested permission to build a large retail store at a location adjacent to the intersection of an undivided four-lane major road and a two-lane minor road.

#### What is the distance measured

A 100-ft cut steel tape was used to check the layout of a building wall. The rear surveyor held 71 ft while the head surveyor cut 0.68 ft. What is the distance measured?