Determine the cross-sectional dimensions of aluminum tube
Course:- Mechanical Engineering
Reference No.:- EM131146214

Assignment Help
Expertsmind Rated 4.9 / 5 based on 47215 reviews.
Review Site
Assignment Help >> Mechanical Engineering

A video camera, of mass 2.0 kg, is mounted on the top of a bank building for surveillance. The video camera is fixed at one end of a tubular aluminum rod whose other end is fixed to the building as shown in Fig. 3.50. The wind-induced force acting on the video camera, f(t), is found to be harmonic with N.


Determine the cross-sectional dimensions of the aluminum tube if the maximum amplitude of vibration of the video camera is to be limited to 0.005 m.

Put your comment

Ask Question & Get Answers from Experts
Browse some more (Mechanical Engineering) Materials
Many of the solid surfaces for which values of the thermal and momentum accommodation coefficients have been measured are quite different from those used in micro- and nanod
An automotive radiator cools glycerine from 95 degrees C to 55 degrees C, Air flows through it, entering at 20 degrees C and leaving at 25 degrees C.  If the radiator is desig
Twenty pounds of a gas mixture is contained in a tank with volume 30 cubic feet at 30 psia and 70 F.  The gas mixture has volumetric analysis of twenty percent carbon dioxide,
A natural gas (methane) pipeline is to be designed to transport the gas at a rate of 50,000 scfm. The pipe is to be 6 in. ID, and the maximum pressure that the compressors can
An electronic control system for an automobile engine is to be mounted on top of the fender inside the engine compartment. It is desirable to isolate the module from the vibra
If the cyclone body is 0.6 m in diameter and the average tangential velocity is 16 m/s, what is the radial velocity near the wall of particles 20 and 40mm in size? How much
Prepare dimensionless performance curves for the 205-mm-diameter radial flow pump of Fig. 12.6. Compare these with the curves shown in Fig. 12.12. Can you explain why there
Based on the information discussed in fender design and ships characteristics, estimate the size and number of fenders that will be required for budgeting purposes. Basis fo