Determine lengths l1 and l2 so the two materials elongate

Assignment Help Civil Engineering
Reference no: EM13315505

a solid cylinder of 50 mm diameter and 900 mm length is subjected to a tensile force of 120kN. One part f the cylinder L1 long is of steel, the other part, fastened to steel, is aluminum and is L2 long. Determine lengths L1 and L2 so the two materials elongate an equal amount. What is the total elongation of the cylinder? Est=200GPa; EAl=70GPa

Reference no: EM13315505

Questions Cloud

What is the kinetic energy of the electron : An electron is released from rest at the negative plate of a parallel plate capacitor and accelerates to the positive plate, What is the kinetic energy of the electron just as it reaches the positive plate
What is the pressure difference measured by the manometer : The "U"-tube manometer containing mercury of density 13600 kg/cubic meters is used to measure the pressure drop along a horizontal pipe. If the fluid in the pipe has a relative density of 0.8 and the manometer reading is 0.6 meters
What are the interface design boundaries and issues : what are the interface design boundaries and issues for the design and installation of a new toilet for a building
Small game development : Small game development - the development has to be done in PROLOG LANGUAGE.
Determine lengths l1 and l2 so the two materials elongate : a solid cylinder of 50 mm diameter and 900 mm length is subjected to a tensile force of 120kN. One part f the cylinder L1 long is of steel, the other part, fastened to steel, is aluminum and is L2 long.
What is the percentage error in the bulk unit weight : What is the percentage error in the bulk unit weight if the soil is the percentage error in the bulk unit weight if the soil is 95% saturated but assumed to be 100% saturated
Determine which driver will be first to displace laterally : Vehicles A and B are traveling toward each other in the opposing lanes on a straight segment of a two-lane highway at 35 and 40 mph respectively. If the critical rates of angular change of the two drivers are 0.0065 and 0.0055 rad/s,
Write a brief explanation about why the directors duty : Write a brief explanation about why the directors' duty to prevent insolvent trading exists and the circumstances and consequences of the ‘veil of incorporation' being lifted for insolvent trading.
Determine the mass of the lead block : A lead block is suspended from the underside of a 0.8 kg block of wood of density of 720 kg/m3. determine the mass of the lead block

Reviews

Write a Review

 

Civil Engineering Questions & Answers

  Determine what does the equation reduce to in steady flow

Define what each term in the equation means. Overall, what quantity is being conserved? Under what conditions might you be justified in assuming that non-linear terms are not important

  Explain how to determine the max height of a brick wall

Assuming a density of 120/ft^3 for masonry brick work, determine the max height of a brick wall if the allowable compressive stress is limited to 150/in^2 and the brick is a) 4" wide b) 6" wide.

  Calculate the unit weight and dry unit weight of the soil

A cube of moist soil weighs 330 lb and has a volume of 3.00 ft3. Its moisture content is 27.0% and the specific gravity of solids is 2.72. Compute the void ratio, porosity, degree of saturation, unit weight and dry unit weight of this soil.

  Determine the required pumping rate

Four pumps are to be used in 0.5-m diameter wells at the four corners of the site. Determine the required pumping rate. The aquifer has T = 1600 m^2/day and the wells each have a radius of influence of 600 m.

  Determine the stoichiometric oxygen requirement for fuel

Determine the Stoichiometric oxygen requirement (pounds of oxygen per pound of fuel) for a fuel containing by weight 50% n-octane,25% 1-heptene and 25% methanol.

  Determine linear velocity of the wastewater in the pipe

A wastewater treatment plant must disinfect its effluent before discharging the waste water to a near-by stream. The wastewater contains  4.5x10^5 fecal coliform colony-forming units (CFU) per liter.

  Pressure on the soil if theta is given

A pipe is to be installed under the ground on a bed of aggregate 6 in. thick. The entire weight on the aggregate from pipe and soil above the pipe is 1800 lbs. per linear foot of pipe. What is the pressure on the soil if theta is 45 degrees? Assum..

  Find the absolute-gage and vacuum pressure heads

A glass jar is heated in an oven and sealed when the air pressure is 103 kPa and the temperature is 105 C. Find the absolute, gage, and vacuum pressures in the jar when it cools to 20 C.

  Volume of the lake

Suppose that the distance from the lake outlet to the withdrawal cannot be more than 20 mi. What should be the new volume of the lake?

  Determine the vertical displacement of the pointer at e

Bars AB and CD are made of A-36 steel and 2014-T6 aluminum alloy,respectively. When the temperature is at 75degreeF, ACE is in the horizontal position.

  Determine the distances the spacecraft must be from moon

consider a spacecraft that is positioned directly between the earth and moon.the mass of the moon's is approximately 7.35 X10^22 kg, and at the instant under consideration, the moon is 3.8 X 10^8 km from earth.

  Determine water level rise in an unconfined aquifer produced

Determine the water level rise in an unconfined aquifer produced by a seasonal precipitation of four inches. The aquifers porosity is 20 percent and its specific retention is 9 percent.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd