Determine by trigonometry corresponding magnitude of r

Assignment Help Civil Engineering
Reference no: EM13315191

Two forces are applied as shown to hook support. Knowing that the magnitude of P is 35 N, determine by trigonometry (a) the required angle a if the resultant R of the two forces applied to the support is to be horizontal, (b) the corresponding magnitude of R.

Reference no: EM13315191

Questions Cloud

Hat is the direction of the net electrical field : Consider two particles, each with a charge of +Q located at the opposite corners of a square of side d. What is the direction of the net electrical field at point P
Determine the average normal stress at the critical section : two 10 mm thick steel plates are fastened together by means of two 20mm bolts that fit tightly into the holes. if the joint transmits a tensile force of 45 kn determine the average normal stress in the plates at a section where no holes occur
How to decrement the ttl field of the packet : In addition to the above-mentioned  KeyboardInterrupt (used to terminate the program), you will need to handle any I/O-related exceptions.
Determine the magnitude and location of the resultant force : The tank contains water to depth of 2m and oil (SG=0.8) on top of the water to a depth of 1m. Determine the magnitude and location of the resultant force acting on one end of the tank (i.e. 3m high by 3m wide).
Determine by trigonometry corresponding magnitude of r : Knowing that the magnitude of P is 35 N, determine by trigonometry (a) the required angle a if the resultant R of the two forces applied to the support is to be horizontal, (b) the corresponding magnitude of R.
What are the predominant types of bond in each category : what are the three meterials based on the predominant types of bond and what are the predominant types of bond in each category
Concept of environmental sustainability : Discuss the concept of environmental sustainability. Discuss the challenges to sustainability faced by developed, emerging, and survival economies. Do you think the “green” movement is a fad, or is it here to stay? 200 Word Maximum
Effects on american society : Define industrialization and describe its effects on American society from 1865-1917
Estimate the vertical hydraulic conductivity using the heads : Write Darcy's equation in 2-D. There are three piezometers in an unconfined sand aquifer as shown below. The head measurements at A = 104.56 ft, B = 104.53 ft, C = 103.42 ft. The rate of recharge here is estimated to be 1.25 ft/yr.

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the minimum chain length for the application

A motorcycle sprocket on the rear wheel has a diameter of 24 cm, and trhe driver sprocket has a diameter of 4.0 cm. The driver sprocket shaft and rear axle are 60 cm apart.

  Estimate the moisture content and moist density

A 0.4m^3 moist soil sample has the following: Moist mass = 711.2 kg, Dry mass 623.9 kg, Specific gravity of soil solids = 2.68 Estimate: a). Moisture content. b). Moist density.

  Determine maximum allowable compressive force can be applied

The force is applied at the two pins. The pins allow rotation around the z-axis and do not allow rotation around the y-axis. The length of the beam between the pins is 8m. Determine the maximum allowable compressive force that can be applied.

  What would be the void ratio of the clay at the point

At a point in a saturated normally consolidated clay layer the soil is subject to an in-situ vertical effective stress of 50kPa. The soil at the point has a moisture content of 44% and a compression index of 0.45.

  Calculate the longitudinal and transverse stresses

Calculate the overall modulus of the composite, explaining your calculations and the assumptions you have made when it is loaded:

  Describe the present land capability classification system

Describe the present land capability classification system for agriculture in the caribbean, Identifying its limitations and propose recommendations. 200 word limit

  Find what is the second year book value for equipment

what is the second year book value for equipment with an initial cost of $11,000, a salvage value of 1,000 and a recovery period of 5 yrs for A. straight line depreciation. B. Double declining balance. C. MACRS

  Calculate the apparent porosities if the matrix is quartz

The dry weight of a core is 28.20 gm. When saturated with a brine having a density of 1.15 gm/cc, the weight increases to 31.50 gm. Calculate the apparent porosities if the matrix is 1) quartz or 2) calcite.

  Calculate volume of sample that will be used in bod bottle

If a sample for BOD needs to be diluted by a factor of 0.02 , calculate the volume of sample that will be used in the BOD bottle

  Decide how many units would like to use and dimensions

The plant will be designed with a rapid mix unit followed by flocculation and sedimentation basin. The water source has an average winter water temperature of 40 and an average summer water temperature of 70oF.

  How far above the hanging location does the target swing

A clay ball (m=0.82 kg) is thrown at a metal target (M=1.72 kg) that is suspended from a cable. The ball is released 1.5 m above teh ground at an angle of 32 degrees.

  Determine cunningham correction factor at standard condition

For a .15 micrometer diameter spherical particle (density of particle = 2500 kg/cubic meter) determine the Cunningham correction factor at standard conditions.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd