Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
An analog LTIC system with impulse response function h(t) = u(t+1)-u(t-2) is presented with an input x(t) = t(u(t) - u(t-2)).
(a). Determine and plot the system output y(t) = x(t)*h(t)
(b). Is this system stable? Is this system casual?
If V = 12sin( 2 pi 1800 + 45). What would you read on a DMM Would this voltage be for an inductor or capacitor What would be the frequency and phase What does the 12 stand for Explain.
a) show the truth table b) show an algebraic expression in sum of minterms fom. c) show a minimum sum of products expression d) show the minterms of the complement of each function in numeric form.
the ends of a length of wire are labeleda and b. If the current in the wire is iab = -3A, are electrons moving toward a or b? How much charge passes through a cross section of the wire in 3 seconds?
Design a 2-bit counter that, when f = 1, counts in the repeating sequence: 0, 2, 3, and when f = 0, counts in the reverse direction. Use T flip-flops. (a) Construct a state diagram or state table.
An LED is rated at VF=1.6V to 2.0V at IF=20mA. What value of series resistance is needed to limit the LED current to 20mA when this LED is connected to a 32 v peak source (that is, a source having a peak voltage of 32 v)
A thin metal disk of mass m=2.00 x 10^-3 kg and radius R=2.20cm is attached at its center to a long fiber. When the disk is turned from the relaxed state through a small angle theta, the torque exerted by the fiber on the disk is proportional to t..
A 4KHz audio signal is transmitted by using a PCM system and the quantization level, L is 256. Find transmission bit rate.
A HCS12 ATD is set to 10-bit unsigned mode. The voltage references are set to ground and 1.0V What is the ADT output for a temperature of 81 degrees The temperature sensor measures 0 to 100 degrees with an output of 10 mV/degree.
The distance between two stations in a 10 Mbps LAN using CSM/CD multiple access method is 2,000 meters. Station A sends a long frame first and three micro seconds later, C starts sending a long frame.
1. A potentiometer with a total range of 350° is supplied with a voltage of 12 Vdc. Find the output voltage for an angle of 135°. 2. An absolute optical rotary encoder has five tracks. How many bits is the output.
(b) This voltage is measured using a defective voltmeter, which always indicates a lower reading than the actual value. Suppose the voltmeter reading is 2.5*10^(-4). Calculate the probability that the error is not more than 0.5 *10^(-4).
A box contains 50 diodes of which 10 are known to be bad. If the first diode drawn from the box was good, what is the probability that a second diode drawn will be good
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd