Reference no: EM131089951
You will design the analog hardware for a data-acquisition system to measure displacement (i.e., vibrations, distance). The range of displacement is -1 to +1 mm. Each resistance in the bridge (R1, R2, R3, and R4) is linear to displacement having a sensitivity of 10 Ω/mm. At zero displacement, all four resistors are 1000 Ω. The displacement signal exists in the 0 to 1000 Hz frequency band. With displacement equal to -1 mm, R1 = 1010, R2 = 990, R3 = 990, and R4 = 1010 Ω With displacement equal to +1 mm, R1 = 990, R2 = 1010, R3 = 1010, and R4 = 990 Ω.
a) Create a design table with displacement R1, R2, R3, R4, bridge output (V2-V1), and ADC input.
b) A good CMRR is required. Design the analog circuit using just the single +5 V supply mapping the bridge output (V2-V1) into the ADC input channel 3 (V3). You do not need to add an antialiasing analog low-pass filter. Show chip numbers, resistor values, but not pin numbers.
Observed market yield on a four-year note
: How could you explain the fact that the observed market yield on a four-year note is 3.5% instead of the yield that you found above?
|
What is meant by assimilation and why is it important
: What is meant by "assimilation" and why is it important for understanding racial and ethnic differences in attitudes toward marriage
|
If you were in charge at 3m what would you do
: MGMT 1100, CH 7 - You are to define the 10 terms below in your own word and competition between old and new technologies to establish a new technological standard - If you were in charge at 3M, what would you do?
|
Standard direct materials cost per bar of chocolate
: Choco La Ti-Da Company produces chocolate bars. The primary materials used in producing chocolate bars are cocoa, sugar, and milk. The standard costs for a batch of chocolate (4,500 bars) are as follows:
|
Design the analog circuit using just the single +5 v supply
: A good CMRR is required. Design the analog circuit using just the single +5 V supply mapping the bridge output (V2-V1) into the ADC input channel 3 (V3). You do not need to add an antialiasing analog low-pass filter. Show chip numbers, resistor va..
|
How are community resources related to family structure
: How do they measure community resources? Why do they feel that both measures are necessary? How are community resources related to family structure
|
Budget estimates of sales-costs
: As a preliminary to requesting budget estimates of sales, costs, and expenses for the fiscal year beginning January 1, 2017, the following tentative trial balance as of December 31, 2016, is prepared by the Accounting Department of Regina Soap Co...
|
Do parent-child interactions differ by family structure
: Why might we expect the relationship between living in a single parent family and the likelihood that children experience a negative outcome be related to the quality of parenting? Do parent-child interactions (e.g., time together, supervision, et..
|
Choose the sampling rate explain why you chose that value
: Write the entire program that implements this real-time data-acquisition system. You are allowed to call the following functions (without showing the implementations of these functions).
|