Design an active first-order rc low-pass filter

Assignment Help Electrical Engineering
Reference no: EM13258882

Design an active first-order RC low-pass filter (using a 741 op-amp) with a cut-off frequency of 10 kHz and a band-pass gain of 20 dB. Derive the step response and voltage transfer function.

Reference no: EM13258882

Questions Cloud

Compute the percentage total return : Suppose a stock had an initial price of $88 per share, paid a dividend of $2.10 per share during the year, and had an ending share price of $77.
Question regarding the zonker company : On July 6 Zonker Company acquired the plant assets of Doonesbury Company, which had discontinued operations. The appraised value of the property is:
What about the employees themselves : What about the employees themselves? Do they inflate their duties or act differently if they know they are being watched during a job analysis? How can we level for this if we suspect it is occurring?
Present value of the given annuities : What is the present value of the following annuities? a. $2,500 a year for 10 years discounted back to the presentat 7 percent b. $70 a year for 3 years discounted back to the present at3 percent
Design an active first-order rc low-pass filter : Design an active first-order RC low-pass filter (using a 741 op-amp) with a cut-off frequency of 10 kHz and a band-pass gain of 20 dB. Derive the step response and voltage transfer function.
What is the after-tax cost of preferred stock : A firm is paying an annual dividend of $2.65 for its preferred stock which is selling for $57.00. There is a selling cost of $3.30. What is the after-tax cost of preferred stock if the firm's tax rate is 33%?
What heat sink temp is necessary to ensure safe operation : A power transistor for which Tjmax=180degrees Celsius can dissipate 50Watts at a case temperature of 50degrees. If it is connected to a heat sink using an insulating washer for which the thermal resistance is .6degrees Celsius/Watt
Which method provides for more goal congruence : Compare the evaluation of the office managers that would be made under the original table and the table you have justcreated.
Discuss any implications the court : Refer back to the Appendix you studied in Unit I on pages 22-24 regarding reading and briefing cases. Taking this information, prepare a brief of the Smith v. Murrell case on pages 303-304.

Reviews

Write a Review

 

Electrical Engineering Questions & Answers

  How many spare tubes must the building custodian maintain

The time to failure of fluorescent lights in a large office building is exponentially distributed with a failure rate of 0.03125 hours. How many spare tubes must the building custodian maintain to have at least a 0.95 probability of replacing all..

  Find what is the data contained in the event counter

The 9S12G128 event counter is configured and enable for rising edge. A 0.5 Hz waveform (TTL logic levels) is applied to the counter input. With the counter starting at 0x0010, what is the data contained in the event counter

  Explain current and average power delivered to the load

Current and average power delivered to the load, A load has a 20 ohm resistor and a 4 henry inductor connected in series. It is connected to a power source with v(t)= 100cos50t

  Find the first five samples of the impulse response

Given the following IIR system with zero initial conditions: y[n]=0.2 x[n]- 0.5y[n-1] -0.06y[n-2] a)find the first five samples of the impulse response b) find the first five step response

  At what forward voltage does a diode conduct a current

At what forward voltage does a diode conduct a current equal to 1000 Is. In terms of Is, what current flows through the same diode when its forward voltage is 0.7V.

  Design a 4-bit decrementer using half-adders

Design a 4-bit decrementer using Half-adders and inverters as building blocks. The circuits impleents A-1=S. Draw the circuit diagram. Hint: consider addtion of the 2s complement of -1 =1111. Begin with a 4-bit adder circuit constructed with 1-bit..

  Determine the value required for any pre-scaling

A PWM is used in 8-bit mode to produce a signal with a 1 msec period and 60% duty cycle. Determine the value required for any pre-scaling, and the values for the period, and duty cycle registers. The E-clock is 24 MHz.

  What is the estimated rise time and the estimated overshoot

A certain unity feedback control system has the closed-loop transfer function: T(s)= Y(s)/R(s)= (s/10+1)/((s/100+1)*(((s/20)^2)+s/20+1))) a) What is the estimated rise time b) What is the estimated overshoot

  Design low pass active filter with a cutoff frequency

Design low pass active filter with a cutoff frequency t at 10kHz or more by 30db and have the pass band gain positive that does not deviate from 20db by more than 3db. The pass band frequency needed is 800Hz and below Derive transfer function

  How to design a simple unipolar drive circuit

Design a simple unipolar drive circuit such that the electrical time constant is 2 msec at phase turn-on and 1 msec at turnoff. The stepping rate is 300 steps per second. A three-phase variable-reluctance stepper motor has parameters.

  Determine what is the maximum zener current allowed

For an ideal Zener, is the Zener voltage is 15v and the power rating is 750mW, what is the maximum zener current allowed What is the relationship between base current and collector current called

  What is the filter attenuation at a frequency

You are designing a PCS base station that operates at 1800 MHz. The receiver is co-located on a tower with UHF police and business radio systems that operate at 450 MHz. Since the the 4th harmonic from the UHF system is directly in the PCS band

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd