Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Design a datapath which will do one of the following. (1) add the value in register A to the calue in one of the registers R0 through R3 and store the result back in A, (2) subtract the value of one of the four registers R0 through R3 into register A. The input to the datapath should be control signals op, sel, and in. The signal op is 1-bit: if op is 1 then add, if op is 0 then subtract. The signal sel is two bits and chooses which of the four registers will be involved in the operation. The signal "in" is one bit: if in = 1 then preform addition or subtraction. if in = 0 then preform the move operation.
A 5-volt intelligence amplitude causes the frequency to change to ± 25 kHz. What will be the carrier frequency variation corresponding to an intelligence amplitude of 10 volts
design a system comprising a pulley actuated by a stepper motor to lift objects of maximum mass of 1kg. No gear box is required. A 48 VDC power source is available. Select a pulley (specify the diameter) and a stepper motor.
A waveform generator has been setup with a square wave output at 4.0kHz with a 81% duty cycle. If the peak-to-peak output amplitude has been set to 6.0V, with an offset of -1.0V, what is the maximum voltage of the output waveform
Develop a voltage-to-current converter that satisfies the requirement I = 0.0021Vin. If the op amp saturation voltage is ±12 V and the maximum current delivery is 5 mA, find the maximum load resistance.
Consider an AlGaAs based heterostructure laser diode which has an optical cavity of length 200 microns. The peak radiation is at 870 nm and the refractive index of GaAs is about 3.7. What is the mode integer m of the peak radiation
What is the function of the enable control input of a tri-state buffer. If the output of two or more tri-state buffers is connected to each other, what is the restriction on enable control input lines.
With |V| = 100 V, the instantaneous power p(t) into a network N has a maximum value 1707 W and a minimum value of -293 W. Find a possible series RL circuit equivalent to N.
A short distance system is composed of two identical transmission lines with an amplifier between them. A 1 mW signal is transmitted at one end and is received at the other end with an SNR of 22 dB.
In a balanced three-phase system the Y-connected impedances are 3∠60°Ω. If V_bc=480∠-75° V, find current of phase "b" in polar form.
An Electric Range top burner control adjusts the duty cycle of the current and voltage supplied to surface heating element as a function of the control's dial setting. The range controller operates from a 240 VRMS single phase supply
a circuit for an ac voltmeter utilizes a moving-coil meter that gives a full-scale reading when the average current flowing throught it is 1mA. The moving-coil meter has a 50-ohm resistance.
Determine a suitable sampling frequency. Design a notch filter to remove the 50Hz component, paying particular attention to any assumptions you have made in the design.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd