Define transmit power

Assignment Help Electrical Engineering
Reference no: EM13141393

The signal to noise ratio at the receiver is required to be at least 17 dB. The average noise power at the receiver is 1 mW. The cable loss between the transmitter and the receiver is 2.5 dB/km and there is 55 km of cable between the transmitter and the receiver. There is a 25 dB amplifier between the transmitter and receiver. Determine the transmit power at the transmitter to achieve a signal to noise ratio of 17 dB at the receiver?

Reference no: EM13141393

Questions Cloud

Compare to comparable statutes in the rest of the world : How does it compare to comparable statutes in the rest of the world?
How many grams of co2 are formed : When 284.5 g of ethylene (C2H4) burns in oxygen to give carbon dioxide and water, how many grams of CO2 are formed?
Determine whether the mdh genotypes in this population : Three alleles are found at a locus coding for malate dehydrogenase (MDH) in the spotted chorus frog. Chorus frogs were collected from a breeding pond, and each frog's genotype at the MDH locus was determined with electrophoresis.
Adjustments on the consolidated worksheet : When a parent uses the initial value method throughout the year to account for its investment in an acquired subsidiary, which of the following statements is true before making adjustments on the consolidated worksheet?
Define transmit power : The signal to noise ratio at the receiver is required to be at least 17 dB. The average noise power at the receiver is 1 mW. The cable loss between the transmitter and the receiver is 2.5 dB/km
Stem cell research legislation in the united states : What is the history of stem cell research legislation in the United States?
Policy proposal research essay : I am writing a policy proposal research essay, my problem is going to be hazardous waste. I need a proposed solution but I'm not sure what a solution can be that is not already been tried.
What price would you expect stock to trade immediately : f the company decides on a 2- for- 1 split, at what price would you expect the stock to trade immediately after the split goes into effect? Why do you think Fido’s board of directors decided to split the company’s stock?
Where might you find vine plants : Where might you find vine plants? Why do epiphytes and succulents share similar stem structures, and is there some similarity in the conditions under which the two plants grow? are there other groups of plants that exhibit secondary growth other t..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Explain what is the db bandwidth of the amplifier

A 1 kHz sine wave signal with a power level -10 dBm is applied to the input of the amplifier. What is the power at the amplifier output in dBW?

  Examining harmonic content of ac voltage waveforms

Analysing harmonic content of ac voltage waveforms, An a.c. voltage, V, comprises of a fundamental voltage of 100 V rms at a frequency of 120 Hz, a 3rd harmonic which is 20% of the fundamental

  Explain moore sequential circuit

Moore sequential circuit, A Moore sequential circuit has one input and one output.The output goes to 1 when the input sequence 111 has occurred and the output goes to 0 if the input sequence

  Explain what is the impedance of the load

A load has a 20 ohm resistor and a 4 Henry inductor connected in series. It is connected to a power source with v(t) = 100 cos(50t), connected in series to the load. What is the impedance of the load? Use phasor transform methods to obtain your an..

  Explain electronic technology in relationship to the use

electronic technology in relationship to the use of personnel and access control, surveillance, and identification of authorized personnel.

  Define a sinusoidal voltage with a peak-to-peak value

A sinusoidal voltage with a peak-to-peak value of 15 v is applied to an RC high-pass filter. If the reactance at the input frquency is zero

  Frequency division multiplexing

Write a short technical report on Frequency Division Multiplexing

  Define zener diode

Zener diode, Can You show me how to solve the following: If a 5k resitor is connected between the cathode of a 6.2V ZENER diode and a 12V power supply.

  Explain how an electric shock may occur

A process worker received an electric shock when she attempted to turn off a conveyer control. The toggle switch controlled the power to a variable speed drive. An examination found that dust had accumulated on the toggle switch. Moisture on the ..

  Explain deploy a wireless telephone system

You have a bandwidth of 10 MHz (per direction) in a single-cell system and want to deploy a wireless telephone system. You have the following options: analog 30-kHz channels (as in AMPS)

  Explain saturated and unsaturated synchronous reactance

Saturated and unsaturated synchronous reactance, The following readings are taken from the results of an open- and a short-circuit test on a 9375-kVA three-phase Y-connected

  Intelligent fan controller based on temperature

Need the coding for the circuits and its a intelligent fan controller based on temperature?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd