Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A continuos-time system is given as a differential equation:y''(t)+2y'(t)+3y(t)=x'(t)+x(t-2)a. Compute the Transfer function H(s) of the system.b. Compute the Impulse Response h(t).c. Compute the Step Response g(t).
How many decimal numbers can be represented by 8-bits. What is the largest positive signed decimal number that can be represented by 8-bits.
Four voice signals. each limited to 4 kHz and sampled at Nyquist rate are converted into binary PCM signal using 256 quantization levels. what will be The bit transmission rate for the time-division multiplexed signal.
Assume that your application has 600 data reads for each 4000 instructions. For the same number of instruction the application has 400 data writes. The cache used has an instruction miss rate of 0.6% and a data cache miss rate of 6%.
1) Two signals are said to be orthogonal if the integral of the product of the signals is 0 over one period of the new (multiplied) signal. Assume x(t) and y(t) are orthogonal energy signals with energy, Ex and Ey, respectively.
A three-phase, 60Hz, wye-connected synchronous generator has balanced line-to-line voltages of 480V at its terminals. The generator is supplying power to two balanced and delta connected, three-phase loads. the first load is made up
Shirlee is working with a measurement tool that reports measurements in centimeters. Since Shirlee is unfamiliar with centimeters, she would like her centimeter measurements to be converted into yards, feet, and inches.
Analyzing the Blink Alive code - Embedded Systems Design
a) Draw a cascade or parallel form for the block diagram representation of the system b) Determine the possible ROC's of this system. For each case determine causality and stability of the system.
What is the maximum message bandwith for which the system operates satisfactorily? Determine the output signal to quantizing noise ratio when a full-load sinusoidal modulating wave of frequency 1 MHz is applied to the input.
Consider the first-order linear differential equation y(t) + 5 (dy(t) / dt) = x(t) Compute the zero-input response (general solution of the homogeneous equation) to find the system-specific part of the response
Scenario/Summary: At least two of the following simulations must be attempted by the student. Verify Loop Analysis Method by MultiSim simulation Verify Superpposition Theorem Method by MultiSim simulation
Signal generator‘s internal impedance is purely resistive and has an open-circuit voltage of 3.5 V. When the generator is loaded with 22 ohms of resistance, its terminal voltage drops to 2.8 V. What is the generator's output impedance (pure resist..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd