Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Application: Single stub matching. A 75 Ω TV cable is used to connect to a TV. The load is matched to the line (Figure 15 .36a). A second TV must be connected 10m from the first TV, again with a matched section of the same cable (Figure 15.36b). Assuming the phase velocity on the line is c/2, calculate:
(a) The reflection coefficient at the location of connection of the two lines.
(b) The standing wave ratio on the line.
(c) Design a single stub (location to the left of the discontinuity and length) to match the line for channel 3 at 63 MHz. Use the same line impedance for the stubs.
(d) For the design in (c) calculate the reflection coefficient to the left of the stub for channel 2 (57 MHz). What is your conclusion from this calculation as far as stub matching across a range of frequencies?
lead experiences corrosion in an acid solution according to the following reaction pb 2h rightarrow pb2 h2 the rates
Perform a detailed comparison between the two options, including but not necessarily limited to a life-cycle exergy analysis and an economic analysis accounting for purchase, installation, operating, maintenance, and disposal costs. Present your f..
A maximum flow rate of 6 CFS is available for a river model. This corresponds to 30,000 CFS for the prototype. What is the scale of the model in terms of the prototype size?
For the case of a guided support at A (figure part (a)), what is the critical load Qcr (In other words, at what ? load Qcr does the system collapse because of Euler buckling of the column DC?
a 45 wt pb-55 mg alloy is rapidly quenched to room temperature from an elevated temperature in such a way that the high
Neglecting radiation and assuming steady-state conditions, calculate the surface temperature of the droplet if the ambient air temperature is 300 K. The latent heat of vaporization is 8.42 X 105 J/kg.
the 14 in. spring is compressed to an 8-in. length where it is realeaed fomr rest and accelerate block a. the
a brick wall 3 m high 7.5 m wide and 200 mm thick has a thermal conductivity of 0.7 wmcelcius. the temperature on the
Consider nodal configuration 2 of Table 4.2. Derive the finite-difference equations under steady-state conditions for the following situations.
retrofit an existing clamp and drill circuit for maximum effeiciency. the cylinder that clamps the part into place is a
(a) What is the weight of the water this boat displaces when floating in salt water of density 1.10 x 103 kg/m3? (b) What is the difference between the volume of fresh water displaced and the volume of salt water displaced?
A flat bar as shown in the figure below is subjected to an axial load F equal to 500 kn. Assuming that the stress in the bar is limited to 200 n/mm^2 determine the thickness of the bar. All dimensions are in mm
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd