Calculate the plasticity index the liquidity index

Assignment Help Civil Engineering
Reference no: EM13555144

A fine-grained soil has a liquid limit of 200% and a plastic limit of 45%. The natural water content of the soil in the field is 60% and the clay content is 63%

a) calculate the plasticity index, the liquidity index, and the activity

b) What is the soil state (e.g., liquid) in the field?

d) The soil is under a rectangular concrete slab 15m x 50m, used as a foundation for a building. A water pipe, in diameter id located in a trench 450mm below the center of the slab. The trench running along the length of the slab,300mm wide and 450mm deep, was backfilled with the same soil. If this pipe were to leak, what effect would it have on the foundation?

* if you could please draw a sketch of the existing trench and pipe, and show in another sketch hou you would mitigate an water related issue form the the and the soil. Explain why your mitigation method is better than the existing construction.

Reference no: EM13555144

Questions Cloud

What concentration of ozone should be injected : Ozone is sometime used as a disinfectant for drinking water. Ozone is highly reactive it will react benign species found in water, as well as the pathogens it is intended to kill.
Determine the percentage increase in the discharge : As part of a drainage improvement project, a drainage ditch will be straightened and cleaned. As a result, the lenght of the ditch will decrease from 1800 ft to 1400 ft and the mannings roughness factor will be reduced
What will be the porosity of the mixture : You are furnished with three sizes of particles. One is gravel with porosity of 0.32, the second is a coarse grained sand with porosity of 0.37, and the third is a fine grained sand with porosity of 0.23. If the coarse grained sand
Determine redox state of sulfur in both the compounds : Derive the porosity values for cubic, orthorhombic, and rhombohedral packing of spheres. Include sketches supporting your calculations of the bulk volumes of the unit cells.
Calculate the plasticity index the liquidity index : The soil is under a rectangular concrete slab 15m x 50m, used as a foundation for a building. A water pipe, in diameter id located in a trench 450mm below the center of the slab. The trench running along the length of the slab,300mm wide and 450mm de..
Will johnsons actions have any implications for future : In this case, it seems clear why Johnson is tempted to omit references to the ambiguous data. He is understandably anxious to graduate and move on to other challenges in his professional life. He is worried that full disclosure of his findings could ..
Determine the volume and density of the body : The volume and the average density of an irregularly shaped body are to be determined by using a spring scale. The body weighs 7200 N in air and 4790N in water. Determine the volume and density of the body. State your assumptions.
What is the absolute pressure at the surface of the mercury : An airplane is flying at 10.6 km altitude. in its nonpressured cargo bay is a container of mercury 325 mm deep. The container is vented to the local atmosphere.
How long will it take for consolidation of a similar clay : A clay specimen, 1 in thick (drained on top and bottom), was tested in the laboratory. For a given load increment, the time for 50% consolidation was 5 min 20 sec. How long will it take for 50 % consolidation of a similar clay layer in the field that..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the maximum efficiency of the cycle

A geothermal power uses hot water (185oF) as a heat source and the cold water from a close by lake (60oF) as a heat sink. The basic operating system is a close loop ammonia efficiency of the cycle that powers turbine-driven electric generator (100..

  Determine the minimum diameter shaft that can be used

The electric motor at A exerts a torque of 800N.m on the steel shaft from A to D. This has a torque of -300N.m at B and -500N.m at C. the dimensions are

  Draw a time-space diagram depicting the above scenario

The transportation agency would like to determine the maximum spacing of stations to allow trains to arrive no more than 5 minutes apart. 1. Draw a time-space diagram depicting the above scenario

  Calculate the critical stressrequired for the propagation of

For a brittle material that has a specific surface energy of 0.26J/m2, and flexural strength and elastic modulus valuesof 76.6 MPa and 64 GPa, respectively, calculate the critical stressrequired for the propagation of a surface crack of length 0.05 m..

  Find range of values of theta for which both cables are taut

A worker ties a rope oflength 12 m to he tower at A and exerts a constant force of 160 Non the rope. (a) Express the tension in each cable as a function oftheta knowing that the resultant of the tension in the cables andthe rope is directed downwa..

  Calculate the overflow rate and effulent weir loading

A wastewater treatment plant has two rectangular primary settling tanks, each 40 ft long, 12 ft wide, and 7 ft deep. The effulent weir length in each tank is 45 ft. The average daily wastewater flow is 387,000 gal.

  Determine what is the minimum coefficient of road adhesion

A rear-wheel-drive 3000lb drag race car has a 200-inch wheel base and a center of gravity 20 inches above the pavement and 140 inches behind the front axle. The owners wish to achieve an initial acceleration from rest of 15 ft/s on a level paved s..

  Determine the subsidence of the clay surface

groundwater is pumped for domestic use from an unconfined aquifer. the thickness of the clay is 40%. after 10 years of pumping, the porosity is reduced to 30%. determine the subsidence of the clay surface.

  Compute the stations of the pc and pt for each curve

An 1100 ft. straight line route survey, which had PI's at3+81.27 (I = 12o30') and 5+42.30 (I = 10o56'), laterhad 600 ft radius simple curves inserted at each PI. Computethe following: a)Curve data for each curve: Da, T, L, LC, E, and MO

  Determine what is the instrumental and statistical error

During an experiment, the depth of a water flow in a flume is measured five times by using a ruler with 1/16-in division. The results from these measurements are 4.88 in, 5.06 in, 5.03 in, 5.13 in, 4.94 in. What is the instrumental error and what ..

  Conclude that the mean cost of the new method is less

It is thought that a new process for producing a certain chemical may be cheaper than the currently used process. Each process was run 6 times, and the cost of producing 100-L of the chemical was determined each time.

  What is the local loss coefficient of the basket strainer

When water flows at 100 m3/hr, the pressure gauge immediately upstream of the basket strainer measures 1 bar. When the basket strainer is clean, the pressure immediately downstream measures 0.9 bar.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd