Calculate the percentage of change in total volume

Assignment Help Civil Engineering
Reference no: EM13561561

A montmorillonite clay has a liquid limit of 160, a plastic limit of 75 and a shrinkage limit of 10. Calculate the percentage of change in total volume with respect to its initial volume when a specimen of this clay is completely dried from a water content of 80%. Assume that the clay remains saturated from liquid limit to shrinkage limit. The solid density of the soil is 2.7 Mg/m3

Reference no: EM13561561

Questions Cloud

The peak time is 1 hour and the recession times is 2 hours : Route a trianglular hydrograph through a 100 foot wide rectangular channel with a bed slope of 0.015 and a Mannings n of 0.035.  Take a distance between cross-sections of 3000 ft.
Determine their common velocity just after the collision : A steel column has a total unbraced height of 14 ft and carries an axial LRFD load of 950 kips. The column ends are fixed. Select an economical HSS 14x14 for this column.
Estimate the stopping distance required traveling northbound : Estimate the stopping distance required traveling northbound along University Drive towards campus assuming you are traveling at 40 mph under normal conditions.
Explain the working principles of two tests that can : Should the soil be compacted at the dry of optimum or at the wet of optimum condition in order to minimize the swelling potential? Briefly explain the reason for your answer.
Calculate the percentage of change in total volume : A montmorillonite clay has a liquid limit of 160, a plastic limit of 75 and a shrinkage limit of 10. Calculate the percentage of change in total volume with respect to its initial volume when a specimen of this clay is completely dried from a water c..
Calculate the coefficient of consolidation and compression : Briefly explain the difference between piezometer and tensiometer with respect to the working principle, special design consideration and limitation of the instrument.
Description marks out : Description Marks out
Determine the return on equity for each of three different : Determine the return on equity for each of three different leverage factors of 0, 0.4, and 0.7.  Assume an interest rate on borrowed funds to be 10% compounded annually.
Explain the reason for the variation of the water : A homogeneous coarse sand deposit has a water table at 10 m depth. The water coefficient of permeability of the sand is found to vary significantly with height above the water table even though the sand deposit is homogeneous

Reviews

Write a Review

 

Civil Engineering Questions & Answers

  Determine the 50-kg crates velocity

If a cylinder of A-36 steel 1 foot long with a diameter of 1 inch is wedged tightly between two immovable isothermal walls and the cylinder is heated from RTt to 300 c what will happen?describe, do not use an equation

  Find the dimensions of an acceptable box of a largest area

a delivery company accepts only rectangular boxes the sum of whose length and girth (perimeter of a cross section) are equal to 108cm. find the dimensions of an acceptable box of a largest area.

  Estimate the concentration and the mass emission rate

Estimate the concentration and the mass emission rate of NOx if a coal containing 1.5% nitrogen is combusted at 1400 k using an air/fuel ratio that is 1.5 times the stoichiometric ratio

  Compute required weight of coarse aggregate per cubic yard

A concrete mix with a 3 inch slump, w/c ratio of 0.50, and sand with a fineness modulus of 2.4 contains 1.700 lb/yd^3 of coarse aggregate. Compute the required weight of coarse aggregate per cubic yard.

  Estimate the amount of coal needed to light one 100-w

A 25-W compact fluorescent lightbulb (CFL) produces the light equivalent of a 100-W incandescent bulb. The population of North America is estimated to be about 305 million. Estimate the amount of coal needed to light one 100-W incandescent lightbulb

  Determine the runoff hydrograph that would be generated

Determine the runoff hydrograph that would be generated by a design 3-hr storm that generates excess rainfall at a constant rate of 10 mm/hr. assume baseflow is constant at 1.0 m3/s.

  Determine rate of change of temperature observed by cyclist

A bicyclist leaves from her home at 9am and rides to a beach 40 miles away. Because of a breeze off the ocean, the temperature at the beach remains 60 degrees F throughout the day.

  How many times will a piezoelectric fatigue testing machine

how many times will a piezoelectric fatigue testing machine take to conduct a fatigue test on a titanium alloy for 10^10

  Doug have to open the door before the 800 mg

Doug decides to use a turkey fryer to prepare the Thanksgiving turkey. Due to cold weather, he prepares the turkey with the door closed, limiting air exchage (Q) within the 40 m3 garage to 0.2 m3 min-1

  What is the elongation of a rectangular bar

What is the elongation of a rectangular bar (cross section 2 inch * 2 inch length 4 ft) When it is subjected to an axial load of 80,000 lbs. Assume the material of the bar has the following properties G = 7,700 KSI, V =0.30

  Determine the flow rate of the oil

Oil of a specific gravity of 0.75 is flowing through a 6-in pipe under a pressure of 15 psi. If the total energy relative to the datumplate is 8.0 ft below the center of the pipe is 58.6 ft, determine the flow rate of the oil.

  What is tension force in the bolts holding the bend in place

The volume of the bend is 0.1 m3. The steel of the bend material weighs 51 kg. Neglecting friction or other losses in the pipe, what is the tension force in the bolts holding the bend in place

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd