Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Calculate the length and diameter of the reaction zone of an afterburner that treats 2000 acfm of polluted air (measured at 250 F). The gases in the afterburner are at a temperature of 1400 F for a residence time of 0.50 sec. Assume the burner will bring in 10 acfm of methane and 350 acfm of outside air (both measured at 80 F and 1atm). The gas velocity in the afterburner is 20ft/sec.
Consider an air bubble rising from the bottom of a lake. Neglecting surface tension, determine approximately what the ratio of the density of the air in the bubble will be at a depth of 34ft to its density at a depth of 8 ft
The meter inlet and throat are connected by the two legs of a mercury manometer. Use the Bernoulli equation to describe how this manometer can be used to measure the flow rate through the meter.
A 3000 lb vehicle has a drag coefficient of 0.32 and a frontal area of 30 ft2. What is the minimum tractive effort required for this vehicle to maintain a 65 mph speed on a 2% upgrade through an air density of 0.002045 slugs/ft3
A survey distance of 369.98 ft was recorded when the field temperatures was 100 degreesF. What is the distance, corrected for temperatures
According to a settlement analysis, the weight of this fill will cause 600 mm of the total settlement over a period of 30 years. The differential settlement will probably be about 100mm. Although the building could be supported on spread footing f..
Determine the effective size as well as the uniformity coefficient and coefficient of curvature for each soil. Determine also the percentages of gravel, sand, silt, and clay according to (a) ASTM, (b) AASHTO, (c)USCS, and (d) the British Standard.
Water flows into and out of a 5 liter tank at a rate of 1 L/min. Within the tank, the mineral apatite is dissolving at a rate of 3x10^-10 moles of Si per m^2 per sec. If the tank contains 10g of the apatite with a specific surface area of 2 m^2/g,
A horizontal prestressing force of 500kN is applied to a rectangular beam. The beam has a depth of 450mm and a width of 250mm. The force is applied at a distance of 60mm below the sections x-x axis.
A stack gas at 1.1 atmospheric pressure has a mixture below. what will be the change in partial pressure of carbon dioxide if the gas temperature is lowered from 2000 degrees K to 1000 degrees K
Based on volume of a sphere V=4/3(pi)r^3, create a table of volume vs. radius allowing radius to vary from 2.0 to 10.0 cm in 1 cm increments. Graph the data from the table on log-log paper using radius as the independent variable.
The channel entrance is rounded and smooth (negligible head loss at entrance), and the reservoir water surface is 2.5 m above the bed of the channel at the entrance. hf=0.00019*Q2, where Q (in m3/s) is the discharge in the channel.
Does Bernard have an unfair advantage over firms having designed the project on which he wants to bid?
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd