### Calculate the effective area of the antenna

Assignment Help Mechanical Engineering
##### Reference no: EM131213004

Effective area of a monopole. The receiving antenna in an AM car radio is 1 m long monopole, vertical above the body of the car. AM reception is between 520 kHz and 1.6 MHz. Calculate the effective area of the antenna at the two extremes of the frequency range.

#### The total heat transfer rate from the plate to the air

Air at 40C flows over a 2m long flat plate with a free stream velocity of 7 m/s. Assume the width of the plate (into the paper) is 0.5m. If the plate is at constant temperatur

#### Derive a set of gibbs–appell equations of motion

The bar is supported by a ball-and-socket joint A. The coefficient of sliding friction between end B of the bar and the wall is µ. Derive a set of Gibbs-Appell equations of

#### What is the resistance of the wire

The magnetic flux that passes through one turn of a 12-turn coil of wire changes to 4.0 from 9.0 Wb in a time of 0.050 s. The average induced current in the coil is 230 A. Wha

#### Prove that there do not exists three irrational numbers

Prove that there do not exists three irrational numbers so that no matter how we choose two of them, their sum is always rational. Let k and n be positive integers satisfyin

#### Calculate the maximum induced bending stress

Assume that the timber member (a) of given Problem is used as a simply supported beam with a 12-ft span length carrying a uniformly distributed load of 500 lb/ft. The given

#### Single plate clutch with both sides of the plate effective

A single plate clutch with both sides of the plate effective is required to transmit 25 kW at 1600 r.p.m the outer diameter of the plate is limited to 300 mm and the intensity

#### Member cb for a condition of equilibrium

A strut CB is guyed back to a wall support through cable BA. Two forces are applied to the concurrent joint at B. Determine the tension in cable BA and the force in member C

#### How to design products using complex 3d cad

ENG661d1 Computer Aided Engineering - how to design products using complex 3D CAD, CAM, simulation and analysis software tools in engineering products development and understa

### Write a Review 