Calculate the corresponding delay-power product

Assignment Help Other Engineering
Reference no: EM131019464

A particular logic gate has tPLH and tPHL of 30 ns and 50 ns, respectively, and dissipates 1 mW with output low and 0.6 mW with output high. Calculate the corresponding delay-power product (under the assumption of a 50% duty-cycle signal and neglecting dynamic power dissipation).

Reference no: EM131019464

Questions Cloud

Demonstrate mastery conceptualizing the problem : Why is this question interesting? Who might care what the results would be - Any other thoughts or ideas you might have regarding this research issue.
What is the maximum number of units of butter macroland : Suppose Macroland is currently producing 40 guns. What is the maximum number of units of butter Macroland can produce if it continues to produce 40 guns
What reductions in maximum operating frequency : To reduce its dynamic power dissipation, operation at 1.8 V is considered. It is found, however, that the currents available to charge and discharge load apacitances also decrease. If current is (a) proportional to VDD or (b) proportional t V2 D..
Discuss the various ways that hazardous chemicals can enter : List the six major categories of occupational illnesses,m and give three examples of each. What are some methods that can ve used to control potential exposures in the workplace?
Calculate the corresponding delay-power product : A particular logic gate has tPLH and tPHL of 30 ns and 50 ns, respectively, and dissipates 1 mW with output low and 0.6 mW with output high. Calculate the corresponding delay-power product (under the assumption of a 50% duty-cycle signal and negle..
What additional power can be saved : A collection of logic gates for which the static power dissipation is zero, and the dynamic power dissipation is 10 mW is operating at 50 MHz with a 5-V supply. By what fraction could the power dissipation be reduced if operation at 3.3 V were pos..
Graph line containing given pair of points and find slope : Graph the line containing the given pair of points and find the slope. Is the system consistent or inconsistent? Are the equations dependent or independent?
Find equivalent capacitance at the output node of inverter : In a particular logic-circuit technology, operating with a 3.3-V supply, the basic inverter draws (from the supply) a current of 60 μA in one state and 0 μA in the other. When the inverter is switched at the rate of 100 MHz, the average supply cu..
Describe a few symptoms of the disease : Describe an autoimmune disorder, other than multiple sclerosis, colorectal cancer, psoriasis, asthma, respiratory syncytial virus infections, Crohn's disease, and rheumatoid arthritis.

Reviews

Write a Review

 

Other Engineering Questions & Answers

  Find the number of strongly connected components

Find the number of strongly connected components in the graph and compute the in-degree centralization of the graph and compute the modularity score associated with that community structure in G.

  Coefficient of friction between tires and pavement

A motorist traveling at a speed of 108 km/h suddenly applies the brakes and comes to a stop after skidding 75 m. Determine

  Determine the angular velocity of the door

A driver starts his car with the door on the passenger's side wide open (θ = 0). The 36-kg door has a centroidal radius of gyration k = 250 mm, and its mass center is located at a distance r = 440 mm from its vertical axis of rotation. Knowing tha..

  Diffusivity of water vapor in air

Temperature of outlet water, 25.3SoC Partial pressure of water in inlet air, 6.27 ton; and in outlet air, 20.1 torr The value for the diffusivity of water vapor in air is 0.22 cm2/s at 0°C and 1 atm. The mass velocity of air is taken relative to t..

  Determine the altitude of the shuttle at point

As it passes through A it fires its engine for ashort interval of time to reduce its speed by 6 percent and begin its descent toward the earth. Determine the altitude of the shuttle at point B, knowing that the angle AOB is equal to50°.

  What would be stakeholders in a project

What would be stakeholders in a project

  Design and draw a circuit using the cascade system

Design and draw a circuit using the cascade system to operate two cylinders (A and B) which, on the operation of a start valve, produces the sequence A - B + B - A+. The cylinders should park in the positions B - A + when the start switch is in th..

  Defining hypertension in a local population issues

What is the proportion of patients suffering from hypertension?

  Design and implement a routine that will resample

The purpose of this laboratory is to design and implement a routine that will resample (upsample and/or downsample) a sequence.

  Determine controller parameters

What use are these measurements when trying to determine Controller parameters and what other measurements can be taken if one is trying to determine PID settings for a controller?

  Discuss some ethical issues faced in engineering design

Discuss some ethical issues faced in engineering design. Provide some examples from our text book and/or the internet and present ideas to resolve those issues

  A survey of 76 commercial airline flights isssues

The national chain wants the estimate to be within one time of the actual mean value. How large a sample should the researcher take to obtain a 98% confidence level?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd