Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A load is drawing 10 A rms when connected to a 1200 V rms supply running at 50 Hz. If the source is operating at a lagging PF of 0.9, calculate (a) the peak voltage magnitude; (b) the instantaneous power absorbed by the load at t = 1 ms; (c) the apparent power supplied by the source; (d) the reactive power supplied to the load; (e) the load impedance; and ( f ) the complex power supplied by the source (in polar form).
A non-inverting operational amplifier circuit is constructed to have a gain of 100 with an input signal of 1 kHz. Would you expect the circuit to have the same gain with the input signal of 1 MHz
A power company supplies 75 kW to an industrial load. The load draws 120 Arms from the transmission line. If the load voltage is 440 Vrms and the load power factor is 0.8 lagging, find the losses in the transmission line.
determine the following by sloving laplace equations: a) the potential and electric field distribution in the dilectric slab. b) the potential and electric feild distrivution in the air space between the dilectric slab and the upper plate and c) t..
Design a 3 th order high - pass Butterworth filter with a High Frequency gain of 20 DB and a cutoff frequency of 20 rad/s. 2) Using MATLAB, plot the frequency respon se of this filter, and the location of the filter poles.
(a) If the excitation volatge Eo is equal to the terminal voltage ( 4kv ), what is the maximum real power which the motor can deliver without losing synchronism (b) What is the rotor pole shift in electrical degrees
using 1/(s+2)(s+4) + c find when the poles are repeated and use that value to calculate the impulse response using laplace transforms. Calculate the step response when c = 10 using Laplace transforms.
Develop a voltage-to-current converter that satisfies the requirement I = 0.0021Vm. If the op amp saturation voltage is ±12 V and the maximum current delivery is 5 mA, find the maximum load resistance.
Using DC Operating point analysis in Multisim (DO NOT USE MULTIMETER INSTRUMENT-NO CREDIT) determine the emitter voltage and emitter current. Provide a screenshot of the results window.
An inverting amplifier is built using an opamp that has a 2V internal offset voltage. (You may consider the opamp ideal otherwise). The circuit uses a feed-back resistor of 2K and an input resistor of 1K. If a 2V input is given to the amplifier
A 52-kg pole vaulter running at 12 m/s vaults over the bar. Her speed when she is above the bar is 0.7 m/s. Neglect air resistance, as well as any energy absorbed by the pole, and determine her altitude as she crosses the bar.
A shunt dc motor has RA = 0.1-ohm and VT = 440 V. For an output power of 16.1 hp, nm = 1,213 rpm and IA = 103 A. The field current remains constant. Find the the rotational power loss in hp.
a.) What isthe minimum sampling frequency to avoid aliasing b.)If the sampling frequency of fs=2500 samples/sec is used how many samples must be taken to give a frequency resolution of 10Hz
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd