Calculate the carbon concentration in steps into the depth

Assignment Help Civil Engineering
Reference no: EM13312547

The decarburization of carbon from a steel with an overall composition Co = 0.3wt% carbon can be expressed by the equation: Cx= Co.erf(z). If the steel is decarburized in vacuum at 1000 C for one hour, calculate the carbon concentration in steps of 0.2 mm as you go into the depth of the steel (starting with x=0 at the surface) until you reach the overall concentration of 0.3 wt % carbon. Given the diffusivity of carbon in Fe = 3 x 10-11m2 per second.

Reference no: EM13312547

Questions Cloud

What is the speed of the wind : A small airplane flies with a speed relative to the ground (ground speed) of 212.0 km/h in a direction 19.0 degrees to the east of north. what is the speed of the wind
Capstone project : Capstone Project
Determine what would be the co concentration in the box : A simple way to model air pollution over a city is with a box model that assumes complete mixing and limited capability for the pollution to disperse horizontally or vertically except in the direction of the prevailing winds
Description of the chosen company including location : Literature review covering the theoretical background and concepts, the topic of the paper, research on the country/organization especially including content from peer-reviewed research articles. Concepts such as entry mode, risks, potential for rewa..
Calculate the carbon concentration in steps into the depth : If the steel is decarburized in vacuum at 1000 C for one hour, calculate the carbon concentration in steps of 0.2 mm as you go into the depth of the steel (starting with x=0 at the surface) until you reach the overall concentration of 0.3 wt % car..
What is the temperature of the liquid : The length of the mercury column at the ice point and steam point are 5.0 cm and 40.0cm respectively. What is the temperature of the liquid
Determine which process requires more energy at atm pressure : Which process requires more energy: completely vaporizing 1 kg of saturated liquid water at 1 atm pressure or completely vaporizing 1 kg of saturated liquid water at 8 atm pressure
A new strategy for kodak : A New Strategy for Kodak
Determine the flow rate of a 2-inch diameter glass pipe : A 2-inch diameter glass pipe is connected to a pipe network in which the pressure is 70 psig. If the length is 300 ft and the outlet is 10 ft above the pipe, determine the flow rate.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine at what rate must generated power be sold in order

The motor-generators installed with these pump-turbines have an efficiency of 0.85 when operating as motors and 0.91 when operating as generators. Each pump-turbine uses its own 100-m-long, 150-cm steel penstock.

  Write expression for velocity of point a in terms of theta

The wheel of radius r rolls without slipping and has an angular velocity w. Write an expression for the velocity of point A in terms of theta and show that the velocities of A and B are perpendicular to one another

  Derive the pollutograph and the loadograph

The average P concentration in the runoff if the overall (agricultural and residential areas) runoff coefficient = 0.4, 40% of P is removed from the agricultural area by rainfall, and 90% of P is removed from the residential area by rainfall.

  Find internal energy by neglecting kinetic energy changes

Water is at 9000 kPa and 300 degrees celcius and flows through a partially open valve. Pressure immediately after the valve is measured to be 600 kPa. Calculate the specific internal energy of the water leaving the valve. Neglect kinetic energy ch..

  Determine the magnitude of f2 which will cause the reaction

Determine the magnitude of F2 which will cause the reaction Cy at the bearing C to beequal to zero. The bearings are in proper alignment and exertonly force reactions on the rod. Set F1 = 550 lb.

  Determine the change in specific enthalpy of the argon

Argon gas is heated in a constant pressure process from 20.0 to 500.°C. Assuming ideal gas behavior, determine: a. The ratio of the final to initial volumes. b. The change in specific internal energy. c. The change in specific enthalpy of the argon.

  Compute minimum value of specific energy and critical depth

A rectangular channel carries a flow of 10 cfs/ft of width. Plot a curve of specific energy vs depth. Compute the minimum value of specific energy and the critical depth. What are the alternative depths for Es = 5.0

  What are the speed and acceleration of the disks top

disk of radius R=7 in. spins at a constant angular speed of w=500rpm in the clockwise direction. If the disk is released from rest far above the ground, what are the speed and acceleration of the disk's top C point after it has fallen h=3ft

  Determine the room temperature when the student comes back

A NCSU student turned on his/her 150 W fan inside his/her room, 4m * 6m * 6m, before going to class in the morning of a summer day, excepting to find his/her room cooler when he/she returns at night.

  How many moles of aluminum

How many moles of aluminum do 5.2×1024 aluminum atoms represent?

  How many shopping trips will be made to each

If a logit model is estimated with coefficients of -0.543 for distance and 0.0165 for commercial space (in 1000 of ft^2), how many shopping trips will be made to each of the four shopping centers?

  Determine what is the bettle stations impact speed

A separatist Droid Army bettlestation is damaged during an intense battle over Coruscant, and it begins to fall towards to planet with an acceleration of s' = -gR^2/s^2 where s is the bettlestation's distance from Coruscant's center

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd