Calculate ph of buffer solution prepared by mixing water
Course:- Civil Engineering
Reference No.:- EM13298388

Assignment Help >> Civil Engineering

Calculate the pH of a buffer solution prepared by mixing 8.5g KH2PO4 with 43.5g K2HPO4 in 1 liter of water (this is actually the composition of the dilution water used in a BOD test.

Follow the same procedures you have been using for previous acid/base equilibrium problems, and develop an Excel spreadsheet to identify the pH.

Use alpha derivations.

Put your comment

Ask Question & Get Answers from Experts
Browse some more (Civil Engineering) Materials
Consider an air bubble rising from the bottom of a lake. Neglecting surface tension, determine approximately what the ratio of the density of the air in the bubble will be a
From historical cost records, the capacity ratio exponent of a process unit is 0.5. Use the capacity ratios raised to an exponent method to determine the estimated cost of a
The azimuth from station A of a link traverse to an azimuth mark is 212o 12' 36". The azimuth from the last station of the traverse to an azimuth mark is 192o 12' 15". Angle
A simply supported steel 'I beam' is made of three 1"*8" plates with a mass of 898.4 lbmass each as shown in I beam form. Steel has a modulus of elasticity of 30*10^6 psi. T
Water leaves a reservoir at 0.05 m^3/s through a 200-mm riveted steel pipeline that protrudes into the reservoir and then immediately turns a 90ยบ bend with a local (minor) l
A left-turn movement has a maximum arrival rate of 200 veh/h. The saturation flow of this movement is 1400 veh/h. For this approach, the yellow time is 4 seconds, all red time
The area of a parking lot is calculated to be 5,474 ft^2 with an estimated standard deviation of 2 ft^2. What is the maximum anticipated error? there is a 90% chance that the
A 300 mm diameter pipe is placed in a 3 m deep rectangular trench that is 0.60 m wide. The trench is backfilled with clay that has a bulk unit weight of 18.8 kN/m3. Compute