Calculate indicated mean effective pressure

Assignment Help Mechanical Engineering

Reference no: EM13707421

A 3L, 4-stroke, V6 engine with a 9.5:1 compression ratio delivers 205 N-m at 3600 RPM. At this speed, air enters the cylinder at 85 kPa and 60 C and combustion ends at 20 crank angle after top-dead-center. It is known that the engine is square and the length of the connecting rods is 16.6 cm. The mechanical efficiency is 85%.

Calculate indicated power.

Calculate indicated mean effective pressure.

Calculate friction mean effective pressure.

Calculate power loss to friction.

Reference no: EM13707421

Questions Cloud

Geoffrey is building an electronic circuit on a breadboard : Geoffrey is building an electronic circuit on a breadboard. He needs to supply his circuit with a 1500 ohm resistance. But he does not have any 1500 ohm resistors on hand. All he has is a box of 1000 ohm resistors.

Determine the maximum shear stress at the point : The stresses at a point in plane stress on a sheet metal roof were found to be sigma_xx = 10 ksi (C), sigma_yy = 20 ksi (C) and Tau_xy = 30 ksi using matrix methods a) determine the normal and shear stresses on a plane passing through the point that ..

Determine the design thrust for a throat area : A rocket nozzle has a chamber pressure of 20 Bar (2 MPa) and a chamber temperature of 2750 K. The rocket is designed to operate isentropically at 12,500 m altitude. Note that the pressure at 12,500 m can be estimated using this equation P/P0 = exp [-..

Determine internal pressure required to initiate yielding : A thin-walled cylindrical pressure vessel is capped at the end and is subjected to an internal pressure (p). The inside diameter of the vessel is 6 ft and the wall thickness is 1.5 inch. The vessel is made of steel with tensile yield strength and com..

Calculate indicated mean effective pressure : A 3L, 4-stroke, V6 engine with a 9.5:1 compression ratio delivers 205 N-m at 3600 RPM. At this speed, air enters the cylinder at 85 kPa and 60 C and combustion ends at 20 crank angle after top-dead-center. It is known that the engine is square and th..

Calculate the mass of fuel injected per cylinder : A direct injection, four-stroke, six cylinder Diesel engine has 10L if displacement volume. Bore and stroke dimensions are 125mm and 136mm, respectively. The engine was designed to deliver 184 HP at 2100 RPM. Calculate the air flow rate (g/s) when pi..

What final fraction of the glasss volume is filled with air : An empty drinking glass is held upside down just above the surface of water. A scuba diver carefully takes the glass, which remains upside down, to a depth of 10.3 meters below the surface so that a sample of air is trapped in the glass. Assume that ..

Similarity and difference between trip and twip steels : Discuss the similarity and difference between TRIP and TWIP steels. Discuss the advantages of TWIP steels. Discuss the effects/roles of Mn, Al and Si in TWIP steels.

Various car and truck spare parts using different steels : Suppose you are appointed as a material engineer at an industry company. The company produces, cutting tools, various car and truck spare parts using different steels. The steels as raw materials to make the parts. All steels are round bars with 50 m..

User Account

All Pages