+1-415-670-9189
info@expertsmind.com
Calculate athe heat lost by the oil and the cooling water
Course:- Mechanical Engineering
Reference No.:- EM13601539





Expertsmind Rated 4.9 / 5 based on 47215 reviews.
Review Site
Assignment Help >> Mechanical Engineering

Hot oil (Cp=2.3 KJ/kg.C) at a rate of 2.5 kg/s enters an adiabatic exchanger at 180 C and leaves at 150 C. Cooling water (Cp=4.18 KJ/kg.C) enters the exchanger at 20 C and leaves at 45 C. Calculate: a) The heat lost by the oil and the cooling water mass flow rate, and b) The entropy generation and irreversibility for this overall process. Take To=25 C.




Put your comment
 
Minimize


Ask Question & Get Answers from Experts
Browse some more (Mechanical Engineering) Materials
Water drips at the rate of 5 drops per second from a leaking tap. Determine the vertical distance between two consecutive drops after the lower drop has attained a velocity
A ball is dropped inside an evacuated tube so that there is no aerodynamic drag acting on the ball. At one point it is at a height of 2.5 m and is dropping at a speed of 1.0 m
Consider a wooden door with a glass window. The door is 5 cm thick and 0.75 m wide by 2 m tall. The window is 0.2 m square and 1 cm thick. The air on one side of the door has
Consider a cold air-standard Diesel cycle. At the beginning of the compression process, the pressure is 0.1 MPa, the temperature is 320 K, and the volume of air is 0.02 m3. Th
A large manufacturing space with an average floor to ceiling height of 30 ft has a floor area of 5000 ft^2. The total infiltration rate for the space is estimated to be 1.5 ai
Calculate the density of Al in g/cm3, given that it forms an FCC crystal structure with an atomic radius of 0.143 nm (10-7 cm) and a mass of 27 g/mole. Avogadro’s number is 6.
Consider two beams, both of length L, with the cross sectional configurations shown. Each beam is subjected to a pure moment, M. Determine the ratio of the maximum principal s
Calculate the applied shear stress, τ (relative to G), which is necessary to bow the dislocations between particles. Would dislocations bow between the particles or shear them