Average mass of the ramp and passengers

Assignment Help Civil Engineering
Reference no: EM13938197

The ramp shown below is used to assist passengers boarding light commuter aircrafts. The average mass of the ramp and passengers is 800 kg with the center of mass located at point G. As the ramp angle θ increases, the hydraulic cylinder extends but the distance between the center of mass G and pivot C remains fixed. 

a) Derive the equation for length AB as a function of BC, AC and θ.

b) Derive the equation for angle BAC as a function of BC, AB and θ.

c) Calculate the pivot reaction force (FC) and hydraulic cylinder force (FAB) at a ramp angle of 10 degrees.

d) Plot the variation of Fc and FAB as a function of θ over the range 10 < θ < 20. 

Consider the plane truss shown below. The reaction force at points A and B act at an angle of α = 30 and β = 22 degrees relative to the horizontal axis.

a) Determine the reaction forces at points A and B.

b) Determine the force in member AH.

c) Determine the force in members BH and BC.

d) Determine the force in members CH and HG.

e) Determine the force in members CD and CG.

Reference no: EM13938197

Questions Cloud

Number of qos levels required to best meet : You should able to demonstrate your QoS policy is working as expected in situation where network is congested with different type of traffic.
Would expect cell body of neuron 1 to be in right hemisphere : Assuming that segmentation of the spinal cord follows a similar pattern in all mammals, approx in which of the 4 major regions of the spinal cord and within which spinal cord structure would you expect to find the axon terminals of neuron 1?
Social capital support innovation : How can social media such as LinkedIn, Facebook and Twitter be used to improe knowledge sharing build social capital support innovation and aid problem solving in one of the following organisational contexts-
How would the deposit be reported in the financial statement : Prepare the entry by Billy Pilgrim to record the delivery of 125 units during 2012. How would the deposit be reported in the financial statements at the end of 2012?
Average mass of the ramp and passengers : The ramp shown below is used to assist passengers boarding light commuter aircrafts. The average mass of the ramp and passengers is 800 kg with the center of mass located at point G. As the ramp angle θ increases, the hydraulic cylinder extends bu..
Fixed price incentive (fpi) contract : The seller has agreed to a fixed price incentive (FPI) contract. The target cost is $450,000 and the target fee is 10% of the target cost. The price ceiling is $540,000 and the buyer/seller share ratio 80/20. The final actual cost is $430,000. Det..
The conversion of binary numbers to decimal numbers : You will need to use a for() loop to process the eight bits. You will need to use a while() loop to access the numbers in the data file (checking for the end of file). This program will help you read data from a data file, valid the data and proce..
Prepare the entry to record the payment of warranty claims : What is the December 31, 2009, balance in the estimated warranty liability account? Compute the warranty expense for 2009. Prepare the entry to record the payment of the 2009 warranty claims.
Damon gain organisational knowledge : A mentor has certain functions in an organisation. Identify the types of support offered by this mentor. What else could the mentor have done to help Damon gain organisational knowledge?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the maximum horizontal distance at a height

determine the maximum horizontal distance that a projectile will have at a height of 60 m above the orgin if it is fired at an angle at 70 degrees from the horizontal with a velocity of 50 m/s

  Determine the power needed for the heater

A cattle watering has a free surface with a size equal to 0.6 m x 0.3m, with the longer side being parallel to the prevailing wind. Wind at -23 C is blowing over the surface at 1 m/s.

  Determine the amount of energy added to the water

A mass of 200g of saturated liquid water is completely vaporized at a constant pressure of 100KPa. Determine a) the volume change b) the amount of energy added to the water

  What is lowest grade possible for the constant-grade section

A tangent section of highway has a -1.0% grade and ends at station 0+1450and elevation 25m. It must be connected to another section of highway that has a -1% grade and that begins at station 1+345 and elevation 40m.

  How large could the plant be without having the ground

A 35 percent-efficient coal-fired power plant with effective height of 100 m emits SO2 at a rate of 0.6 lb/10^6 Btu into the plant. If winds are assumed to be 4 m/s at the stack height and just over 3 m/s at 10 m

  Calculate how much water would the aquifer produce

The specific storage of a 45-m thick confined aquifer is 3.0 X 10^-5 m^-1. How much water would the aquifer produce if the piezometric surface is lowered by 10 m over an area of 1 km^2

  Consider a metal single crystal oriented such that

Consider a metal single crystal oriented such that the normal to the slip plane and the slip direction are at angles of 42.1* and 48.9*, respectively, with the tensile axis. If the critical resolved shear stress is 18.2 MPa (3000 psi)

  Estimate what is the total volume of runoff

It rains 3.0 in. on a 20.0 acre watershed. What is the volume of rainfall excess if 30% of the watershed area is a lake and infiltration on the soil is estimated at 1.0 in. What is the total volume of runoff

  Determine how far upstream of the section would be expected

The slope of the channel So=.15% and the Manning n=.038. Estimate the depth y2=100m upstream of a section where the flow depth y1=2.2m Using a) the direct integration method and b) the standard step method.

  Male coloration is not relevant to this question

Apopulation of pheasants is released onto 6 islands. The pheasantcame from the mainland where predators are common. Three of theislands have predatory fox present (have-predators) and three donot have fox present (predator-free)

  Is inventor claim valid to have an invented adiabatic flow

An inventor claims to have invented an adiabatic steady-flow device with a single inlet-outlet that produces 100 kW when expanding 1 kg/s of air from 900 kPa and 300 degrees C to 100 kPa.

  Developed the triangular weir shape

In 1952 E. S Crump developed the triangular weir shape shown in Fig, the front slope is 1:2 to avoid sediment deposition, and the rear slope is 1:5 to maintain a stable tail water flow. The beauty of the design is that it has a unique discharge co..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd