Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A refrigeration unit operating on R-134a is used to maintain a freezer at -15°C. The refrigeration unit operates at a suction pressure of 140kPa and a discharge pressure of 900kPa. The condenser of the refrigeration unit is cooled by a water cooled heat exchanger. Cooling water flows through the condenser heat exchanger at a rate of 50kg/min, entering at a temperature of 20°C and leaving at a temperature of 29 C. It is known that the refrigeration unit can be modelled as an ideal vapour compression cycle for the heat rejection, throttling and heat absorption stages; however the compressor is known to be non-isentropic. The discharge temperature from the compressor is 60°C.
i) Determine the mass flow rate of the refrigerant, assuming a constant specific heat for the cooling water of Cwater=4.184 kJ/(kg.K).
ii) What is the required power input to the compressor and the isentropic efficiency of the compressor?
Using the formula to compute torque and having a torque of 4966.97, with the RPM's at 250, Would my calculation for horsepower be correct at 236.4 hp?
A steel plane of finite dimension and thickness of 13 mm has the initial (uniform) temperature of 35 C. put the plane into the solution in all sudden and the wall temperature is increased to 146 C spontaneously. The thermo diffusivity of the plane, i..
the hoover dam has a capacity to produce 2080 mw of electrical power. the difference in height between the surface of
Consider a thermal energy reservoir at 1500 K that can supply heat at a rate of 150,000 kJ h-1. Determine the exergy of this supplied energy, assuming an environmental temperature of 25 oC.
a cylinder fitted with a piston has an initial volume of 2 ft3 and contains nitrogen at 20 lbfin2 at 80 f degrees. the
crates a and b weigh 100 lb and 50 lb respectively. if they start from rest determine the their speed when t 5s. also
Using the standard machining parameter formulae for milling, determine the speed (rpm), feed (ipm) and machining time (TM) recommended to horizontal mill ANSI #1018 cold rolled steel that is 1.50 inch long with a 10 tooth 4.0 inch diameter slab mill ..
Describe the main kinds of social mechanisms that are used by people to communicate and collaborate.
What is the inner tube surface temperature at the outlet, where fully developed conditions may be assumed?
the old rigid tank problem a tank has a volume of 600 gallons and holds 300 lbm of water at 40 psig pressure. what is
two suppliers manufacture a plastic gear used in a laser printer. the impact strength of these gears is measured in
a long cylinder of radius ro20cm and thermal conductivity k3 wmk is immersed in a fluid of convection coefficient
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd