An enclosure contains an array of circuit boards

Assignment Help Mechanical Engineering

Reference no: EM13708246

An enclosure contains an array of circuit boards, 15 cm high and 20 cm long. The clearance between the tips of the components on the PCB and the back surface of the adjacent PCB is 0.3 cm. Each circuit board contains 75 square chips on one side, each dissipating 0.15 W of power. Air enters the space between the boards through the 0.3-cm x 15-cm cross section at 40Â°C with a velocity of 300 m/min. Assuming the heat transfer from the back side of the circuit board to be negligible, determine the exit temperature of the air and the highest surface temperature of the chips.

Reference no: EM13708246

Questions Cloud

Determine the final temperature in the cylinder : A vertical piston-cylinder device, which is insulated, initially contains 15 kg of water, 9 kg of which is in the vapor phase. The pressure inside the cylinder is maintained constant at 0.3 MPa by mass of the piston. Now steam at 0.8 MPa and 500 °C i..

Listed below are examples of resumes : Listed below are examples of resumes. Examine the resumes closely. Based on what you've learned this week, what did they do well on their resumes? What did they not do well? Why would improving these be important to a prospective employer?

What is the enthalpy of the water in units : 5.5 kg of superheated water vapor is at 200°C and 1.4 MPa. It is cooled at constant volume to 150°C. What is the enthalpy of the water in units of kJ? (Please note it is asking for the final enthalpy, as well as in units of KJ, not KJ/kg)

Temperature measurement device is calibrated to produce : A temperature measurement device is calibrated to produce 4-20 mA for a temperature operation range of 0-100 degree C. Sketch the input-output characteristic chart of the device, assuming linear input/output relationship.

An enclosure contains an array of circuit boards : An enclosure contains an array of circuit boards, 15 cm high and 20 cm long. The clearance between the tips of the components on the PCB and the back surface of the adjacent PCB is 0.3 cm. Each circuit board contains 75 square chips on one side, each..

Determine amount of heat removed during the cooling process : A rigid container of 0.1 m3 and negligible heat capacity contains steam at 500 kPa and 400C. If the container is cooled, determine the pressure and temperature at which steam starts to condense. Determine also the amount of heat removed during the co..

Develop technical competence in problem formulation : Develop your knowledge of key principles relating to wastewater system design - Develop technical competence in problem formulation and solution in this discipline area.

Determine the mass flow rate of air through the compressor : Air enters the compressor of a gas-turbine plant at ambient conditions of 100 kPa and 32 °C with a low velocity and exits at 1 MPa and 367 °C with a velocity of 6 x 10^3 m/min. The compressor is cooled at a rate of 1800 kJ/min, and the power input to..

Maximum inner diameter for the shaft for a yield strength : A shaft with a 2-inch outer diameter must deliver 5000 ft-lbs of torque. The shaft must be hollow and must simultaneously carry hydraulic fluid at an internal pressure of 30,000 psi. Assuming the shaft is closed-ended, and using the von Mises yield c..

User Account

All Pages