Reference no: EM13964784
Petah, Ltd., of Tel Aviv, Israel, has budgeted costs in its various departments as follows for the coming year:
Factory Administration . . . . . . . . . . . . . . .540,000
Custodial Services . . . . . . . . . . . . . . . . . .137,520
Personnel . . . . . . . . . . . . . . . . . . . . . . . . .57,680
Maintenance . . . . . . . . . . . . . . . . . . . . . . .90,400
Stamping overhead . . . . . . . . . . . . . . . .752,600
Assembly overhead . . . . . . . . . . . . . . . .351,800
Total overhead cost . . . . . . . . . . . . . . . . . .1,930,000
The Israeli currency is the shekel, denoted by. The company allocates service department costs to other departments, in the order listed below.
Stamping and Assembly are operating departments; the other departments are service departments.
Factory Administration is allocated on the basis of labor-hours; Custodial Services on the basis of square meters occupied; Personnel on the basis of number of employees; and Maintenance on the basis of machine-hours.
Required:
1. Allocate service department costs to consuming departments by the step-down method. Then compute predetermined overhead rates in the operating departments, using a machine-hours basis in Stamping and a direct labor-hours basis in Assembly.
2. Repeat (1) above, this time using the direct method. Again, compute predetermined overhead rates in Stamping and Assembly.
3. Assume that the company doesn't bother with allocating service department costs but simply computes a single plant wide overhead rate based on total overhead costs (both service department and operating department costs) divided by total direct labor-hours. Compute the plant wide overhead rate.
4. Suppose a job requires machine and labor time as follows:
Using the overhead rates computed in (1), (2), and (3) above, compute the amount of overhead cost that would be assigned to the job if the overhead rates were developed using the step-down method, the direct method, and the plant wide method.(Round allocations to the nearest wholeshekel.)
Enter the numerical value for the temperature
: Let F denote a certain temperature in degrees Fahrenheit, and C the same temperature in degrees Celsius. Then you can convert between F and F = 32 + 9/5 C. Suppose the temperature is 8 degrees Celsius. Enter here the corresponding temperature in d..
|
Calculate primary terminal voltage and percentage regulation
: The transformer consumes 700W under no-load conditions at rated voltage. Determine the value of load current for which the efficiency is maximum, and evaluate this efficiency at a power factor 0.7 lagging.
|
The experiment was designed to understand absorption of heat
: Wrap one sheet of acetate paper around a clear glass container. Place a thermometer in the glass containers and bring the 100 W light bulb (no lamp shade) to a distance of about 20 cm from the glass container.
|
Write a brief summary paper about given article
: Write one summary article for chapter 8 that gives a brief summary, states a problem the business (or individual) is facing, Make sure to point out any concept in chapter 8 that can be applied.
|
Allocate service department costs to consuming departments
: Allocate service department costs to consuming departments by the step-down method. Then compute predetermined overhead rates in the operating departments, using a machine-hours basis in Stamping and a direct labor-hours basis in Assembly.
|
Augmented matrix of a linear system
: The augmented matrix of a linear system has been transformed by row operations into the form below. Determine if the system is consistent.
|
Describe the solution set of the original system
: The augmented matrix of a linear system has been reduced by row operations to the form shown. explain step by step no matter how small the detail In each case, continue the appropriate operations and describe the solution set of the original syste..
|
What is the frequency when this tension is doubled
: A bell is ringing inside of a sealed glass jar that is connected to a vacuum pump. Initially, the jar is filled with air. What does one hear as the air is slowly removed from the jar by the pump?
|
Calculate the value of kc for the reaction ag+(aq) + cl-(aq)
: Calculate the value of Kc for the reaction Ag+(aq) + Cl-(aq) → AgCl(s) if the concentrations at equilibrium are [Ag+] = 10-8M, [Cl-] = 0.01M.
|