A heat pump with a cop of 30 is used to heat air contained

Assignment Help Mechanical Engineering
Reference no: EM13630864

A heat pump with a COP of 3.0 is used to heat air contained in a 1205.4m^3 of well-insulated, rigid tank. Initially the pressure and the temperature inside the gas tank are 100 kPa and 7 degrees Celsius, respectively. When running, the heat pump consumes 5kW of electric power. How long does it take for the heat pump to raise the temperature of air in the tank to 22 degrees Celsius?

Reference no: EM13630864

Questions Cloud

A mixing chamber steadily mixes a hot water stream at : a mixing chamber steadily mixes a hot water stream at 80degc and 0.5kgs rate with a cold water stream at 20degc. if the
A nozzle with inlet area of 800 cm2 and inlet steam : a nozzle with inlet area of 800 cm2 and inlet steam velocity is 10ms. the steam pressure is 800kpa and temperature is
Using the classical and relativistic expressions for : using the classical and relativistic expressions for kinetic energy calculate the range of velocities for a particle of
Knowing that the constant of eachspring is 2 knm determine : a 10-kg block is attached to spring a and connected to spring b bycord and pulley. the block is held in the position
A heat pump with a cop of 30 is used to heat air contained : a heat pump with a cop of 3.0 is used to heat air contained in a 1205.4m3 of well-insulated rigid tank. initially the
It is now cooled at constant volume to 200 deg c this : a system with an initial volume of 2 m is filled with water at 3 mpa 400 deg c.it is now cooled at constant volume to
A system executes a power cycle while receiving 1050 kj by : a system executes a power cycle while receiving 1050 kj by heat transfer at a temperature of 525 k and discharging 700
Determine the total mass of water remaining in the tank and : a 0.06m 3 rigid tank initially contains water at 1.5 mpa with a quality of 20. the tank is heated and a pressure
Determine the temperature or quality if a saturated mixture : steam enters one inlet of an adiabatic mixing chamber at 1.4mpa and 300 c. at the second inlet steam enters at 1.4mpa

Reviews

Write a Review

 

Mechanical Engineering Questions & Answers

  What is the length of the slope of the ramp

Using the knon height and calculated base lenghth, what is the length of the slope of the ramp.

  An experiment was carried out to calculate forces acting in

an experiment was carried out to calculate forces acting in two members of a pin-jointed framework due to different

  A pitot-static tube is used to measure the airspeed of an

a pitot-static tube is used to measure the airspeed of an airplane. the pitot tube is connected to a pressure sensing

  Calculate the engineering strain

A tensile specimen of cartridge brass sheet has a cross section of 0.320 in. × 0.120 in. and a gage length of 2.00 in. Calculate the engineering strain that occurred during a test if the distance between gage markings is 2.35 in. after the test.

  Determine the largest allowable square cross

Determine the largest allowable square cross section of a steel shaft of length 6 m if the maximum shearing stress is not to exceed 135 MPa

  What is the repair rate

If the unit can perform its function either in State 1 or 2, find the steady-state availability A for the device.

  The exit temperature of hot air is 20degc assuming constant

an adiabatic heat exchanger is used to heat cold water at 15degc entering at a rate of 5 kgs by hot air at 90degc

  A container must be sized to support the load of the

a team of astronomers have proposed io construct a large parabolic telescope mirror by spinning a cylindrical container

  A rigid container is separated into 2 compartments by a

a rigid container is separated into 2 compartments by a very thin solid membrane. one side initially holds 2 m3 of air

  Finally the air is isochorically cooled returning to its

a mass of 1.5kg of air enters a combustion chamber at atmospheric conditions of 100 kpa and 25 degrees c at state 1.

  Determine the peak runoff

Determine the peak runoff from 500 ft of pavement(32ft wide) that drains toward a gutter(for 10 years freq. storm), the pavement slope is .0005, n=.016 and c=.9

  The air leaves the diffuser with a velocity that is very

air at 10 deg c and 80 kpa enters the diffuser of a jet engine steadily with a velocity of 200 ms. the inlet area of

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd